Hasbro 61983 User Manual

EXTENSION BLASTER

™

AGES 6+

1. Load dart into lower muzzle.

CLEARING A JAM

1. Pull Bolt Mechanism back. If Bolt
Mechanism seems stuck, try pulling
the trigger first.

2. Slide the Cocking Mechanism
backwards.

3. Pull the Trigger 1 to launch 1
STREAMLINE DART

™

.

2. Remove the Clip before attempting to
remove the jammed dart.

N-Strike

LongShot CS-6

™

61983

Thank you for purchasing the NERF™ N-Strike LongShot CS-6™
blaster. Be sure to read and follow all instructions carefully before
using this product.

Use both blasters separately or snap them together to create the
N-Strike LONGSHOT CS-6.

CAUTION:

TO AVOID INJURY:

N-STRIKE LONGSHOT CS-6

Clip Lock Button

Do not aim at eyes or face.
Use only darts designed for this product.

Do not modify darts or dart blasters.

™

WITH 12 STREAMLINE DARTS

Jam

Clearing

Door

Sight

™

Ready Indicator

™

3. Open the Jam Clearing Door and
remove the jammed dart. Close door.

© 2006 Hasbro. All Rights Reserved.

® denote U.S. Trademarks.

TM &
U.S.Patent Nos. 6083127, 5529050 and Patent Pending.
61983 P/N 6594260000

Product and colors may vary.

4.

Replace Clip and slide Bolt

Mechanism

forward. This should load another dart.

Questions? Call: 1-800-327-8264

Dart’s Holding Tube

Cocking
Mechanis

m

Trigger 1

Bipod

Clip

Trigger 2

Bolt Mechanism

Clip Storage

N-Strike LONGSHOT CS-6™ To Assemble:

USING LONGSHOT CS-6

1. Insert Bolt into mechanism as shown
and plug onto other end of bolt.

3. Slide/snap Sight onto Blaster. Lock
into place.

5. Attach extension to main unit by
sliding extension into place...

2. Stock extends.

4. Insert grip and slide back to snap
into place.

6. ...and twisting 90 degrees to lock.

1. Pull Bolt Mechanism back. Ready Indicator should change
from black to red. Slide Clip into place.

2. Slide Bolt Mechanism forward.

3. Pull Trigger 2 to launch
STREAMLINE DART

™

.

7. Bipod flips down. 8. Load Clip by inserting 1
STREAMLINE DART

™

at a time
and pushing down. Be sure to insert
darts in direction indicated on the
Clip. Each Clip can hold up to 6
STREAMLINE DARTS.

4. Pull Bolt Mechanism all the way back,
and slide forward to load another dart.

other side of blaster

5. To reload, pull Bolt Mechanism back and press Clip Locking

Button to remove Clip.