Hasbro 61238 Instructions Manual

(3)
(8)
(5)
(10)
(12)
(13)(4)
(9)
(7)
(11)
(11)
(2)
(1)
Some assembly required.
No tools needed.
Includes: unassembled
vehicle and figures.
WARNING:
CHOKING HAZARD-Small parts.
Not for children under 3 years
.
AGES 5+
61238
1. Position control bar with handle as shown. Snap struts onto control bar.
2. Snap rear hydrofoil onto struts that are closest to handle, as shown. Snap front hydrofoil onto remaining struts.
3. Hold control bar handle. Lift front hydrofoil. Slide control bar into hull, making sure control bar slides under tabs. Fold hydrofoils into slots in hull.
4. With long mount in position shown, snap mount over posts on front hydrofoil. Repeat with short mount and rear hydrofoil. Slide handle back and forth to test hydrofoils. NOTE: Put hydrofoils up before continuing.
5. Attach steering wheel and seats to interior. Place assembled interior into vehicle as shown.
6. Insert tab on hull rear into hole in deck rear. Swing deck down and snap tabs on hull into slots in deck.
GI JOE MORAY™ HYDROFOIL INSTRUCTIONS
Product and colors may vary.
© 2005 Hasbro. All Rights Reserved.
® & TM denote U.S. Trademarks.
P/N 6474770000
GI JOE MORAY
HYDROFOIL
STRUTS
CONTROL BAR
HANDLE
REAR HYDROFOIL
FRONT HYDROFOIL
HULL
FRONT HYDROFOIL
CONTROL BAR
LONG MOUNT
SHORT MOUNT
HANDLE
HANDLE
STEERING WHEEL
SEAT
SEAT
INTERIOR
TAB
HOLE
TABS
DECK
NOTE: Adult supervision may be required.
Remove all pieces from plastic frames. If you have difficulty, use safety scissors.
1. HYDROFOILS.
2. TORPEDO.
3. RETRACTABLE MISSILE BOX.
4. DEFLECTOR SHIEL D.
5. CANNONS.
6. PRESS ACTUATOR BUTTON TO REVEAL
MISSILE BOX.
7. SEARCHLIGHT.
8. PASSENGER’S SEAT HOLDS ON E FIGURE.
9. DRIVER’S SEAT HOLDS ONE FIGU RE.
10. TURRET HOLDS ONE FIG URE.
11. M-30 WE APONS.
12. STORAGE AREA.
13. REMOVABLE ENGINE COVER.
15
20
14
6
9
18
12
3
1
7
18
19
21
22
5
10
17
13
11
4
2
8
7. Insert “T” tabs on missile box bottom into holes in missile box top. Slide “T” tabs toward rear of box. Snap rear of missile box together.
8. Insert actuator button into hole in deck. Insert missile box lever into hole in actuator button. Swing missile box into place.
9. Position front of blast shield under top tabs on back of missile box, and place one post on notch under deck. Place other post of blast shield over deck opening and snap into place. Press actuator button to lift missile box. Insert missiles into missile box.
10. Snap hatch covers over hatch openings. Snap lens into searchlight. Attach searchlight to vehicle.
11. Attach left windshield to left side of cabin as shown. Slide windshield between ridge, and press into place. Repeat with right windshield. Attach windshield gun to vehicle as shown.
12. Attach turret gun to turret. Snap turret into turret hole. Attach side missiles to vehicle.
13. Attach left exhaust pipe to left side of engine as shown. Snap bottom of exhaust pipe under engine half. Repeat with right exhaust pipe. Attach tailpipe to exhaust pipes.
14. Place front engine tab into slot in engine compartment, and push rear tab into place. Attach depth charge caps to depth charges. Slide depth charge tray into tray compartments. Lift trays to insert depth charges.
15. Place storage covers over storage areas. Fit engine cover over engine. Insert posts on M-30s into holes in rear deck.
16. Attach torpedo halves. Attach assembled torpedo to vehicle, and slide forward to lock in place. Repeat with other torpedo. Snap cannons onto sides of deck as shown.
17. Peel and apply labels as shown.
TOP
MISSILE BOX BOTTOM
“T” TABS
ACTUATOR BUTTON
HOLE
HOLE
LEVER
BLAST SHIELD
MISSILES
POST
NOTCH
TAB
HATCH COVER
HATCH COVER
LENS
SEARCH LIGHT
WINDSHIELD
WINDSHIELD GUN
RIDGE
TURRET GUN
TURRET
SIDE MISSILES
LEFT EXHAUST PIPE
RIGHT EXHAUST PIPE
TAILPIPE
ENGINE COMPARTMENT
DEPTH CHARGE
CAP
DEPTH CHARGE TRAY
ENGINE COVER
STORAGE COVERS
M-30’s
TORPEDO HALVES
CANNON
CANNON
TORPEDO
M-30’s
Loading...