Hasbro 42792 User Manual

Get a Tiger!
Get the Roar!

Ages 6+

Item No. 42792

TM

INSTRUCTIONS

1

2

Read the instructions below, plug in your Paintball Trainer, and get ready for

AA

AA

AA

AA

some fast blasting action! Begin by sharpening your skills with “shooting gallery”
target practice! The compact size of the marker gun helps younger players learn
and master the shooting technique! Then shoot or be shot as you compete
against your TV opponents in a variety of interesting terrains and exciting
scenarios.

REQUIREMENTS

• TV or VCR with AV input. RF adapter required if TV has no AV input. Or, you
may use the AV input on a VCR that’s connected to your TV.

• Standard glass screen TV only. Not for use with Projection TV, High
Definition TV, or flat screen (Plasma) TV.

Important: You cannot play this game through a cable box or satellite hookup.
Game must be connected directly to the TV or VCR.

To install the batteries, do the following:

1. Use a Phillips head screwdriver to loosen the screw
on the battery compartment door (as shown below)
and open the door.

2. Insert 4 new 1.5V “AA” or LR6 size batteries, making
sure to align “+” and “-” as shown.

3. Replace the battery compartment door and tighten
the screw.

CAUTION: TO AVOID BATTERY LEAKAGE

1. Be sure to insert the batteries correctly and

always follow the toy and battery manufacturers’
instruction;

INSTALL BATTERIES

Requires 4 x 1.5V “AA” or LR6 size batteries (not included). Alkaline batteries
recommended. Phillips/cross head screwdriver (not included) needed to insert
batteries.

2. Do not mix old batteries and new batteries or

alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;

3

4

3. Always remove weak or dead batteries from the
product.

4. Remove batteries if product is not to be played
with for a long time.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use
only batteries specified and be sure to insert
them correctly by matching the + and - polarity
markings.

2. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.

3. Remove exhausted or dead batteries from the
product.

5. Do not short circuit the supply terminals.

6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if
necessary.

7. RECHARGEABLE BATTERIES: Do not mix these
with any other types of battery. Always remove
from the product before recharging. Recharge
batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.

5

6

SET UP

VIDEO PLUG

(YELLOW)

AUDIO PLUG

(WHITE)

VIDEO INPUT

AUDIO INPUT

VCR/DVD

VIDEO PLUG

(YELLOW)

AUDIO PLUG

(WHITE)

VIDEO INPUT

AUDIO INPUT

Connecting to a TV

1. Insert the game unit’s white plug into the white
audio-in jack on the TV.

2. Insert the game unit’s yellow plug into the yellow
video-in jack on the TV.

Note: These jacks are normally found on the front of
the TV near the adjustment controls, or on the back
of the TV near the antenna and cable connections.

5. Set your TV, VCR or DVD player to the channel / video input mode directed by
your TV, VCR or DVD player owner’s manual.

6. Slide the ON/OFF switch on the game controller to ON.

See Troubleshooting Guide at end of Instructions if necessary.

MARKER GUN BUTTONS AND FEATURES

3. Turn on your TV.

4. Set your TV to the channel / video input mode directed by your TV and VCR
owner’s manual.

Connecting to a VCR or DVD

1. Make sure the VCR or DVD player is properly
connected to the TV.

2. Insert the game UNIT’S white plug into the
white audio-in jack on the VCR or DVD player.

3. Insert the GAME UNIT’S yellow plug into the
yellow video-in jack on the VCR or DVD player.

4. Turn on your TV and VCR or DVD.

RESET

SAFETY

HIDE

ON/OFF

TRIGGER