Hasbro 34925, 34904 Instruction Manual

AGES 3+
34925/34904 Asst.
Talking Bear Cub Koda
Talking Bear Cub Koda
Thank you for purchasing this Brother Bear toy! For maximum play value, be sure to read and follow instructions carefully.
Includes 3 x 1.5V "AAA"/R03 batteries. Alkaline batteries recommended. Phillips/cross head screwdriver (not included) needed to replace batteries.
TO PLAY
TO PLAY
PPRREESSSS
LLEEFFTT
EEAARR
After about 15 seconds of non-activation, Koda says, "Ko-da" and shuts himself off. To reactivate, squeeze his left ear.
For best results:
Keep background noise low, or play in a quiet room. Shouting or speaking very loudly does not improve toy’s function.
Wait for Koda to finish speaking before you respond.
Replace batteries if speech begins to slow down or stops completely.
To activate Koda, squeeze his left ear and he’ll say, "Hey there, how are you doin’?" Answer his question and he’ll respond with another question and a fun phrase! To hear another question, just squeeze his hand again.
CAUTION: TO AVOID BATTERY LEAKAGE
1) As with all small batteries, the batteries used with this toy should be kept away from small children who still put things in their mouths. If they are swallowed, promptly see a doctor and, in the U.S., have the doctor phone (202) 625-3333 collect, or, in Canada, have the doctor call your provincial Poison Control Centre.
2) Make sure the batteries are inserted correctly and always follow the toy and battery manufacturers' instructions.
3) Do not mix old batteries and new batteries or alkaline, standard (carbon zinc) or rechargeable (nickel-cadmium) batteries.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries should be replaced by an adult.
CAUTION:
1) Always follow the instructions carefully. Use only batteries specified and be sure to
insert them correctly by matching the + and – polarity markings.
2) Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline
batteries.
3) Remove exhausted or dead batteries from the product.
4) Remove batteries if product is not to be played with for a long time.
5) Do not short-circuit the supply terminals.
6) Should this product cause, or be affected by, local electrical interference, move it
away from the other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
7) RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.
Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
8) As with all small items, these batteries should be kept away from children. If
swallowed, seek medical attention immediately.
Use a Phillips/cross head screwdriver to loosen screw in battery compartment door (screw remains attached to door). Remove door. Remove exhausted batteries and insert 3 x 1.5V fresh "AAA"/LR03 alkaline batteries. Replace door and tighten screw.
TO REPLACE BATTERIES
TO REPLACE BATTERIES
© Disney ®* and/or ™* & © 2003 Hasbro. All Rights Reserved. ® denotes Reg. U.S. Pat. & TM Office. 34925/34904 Asst. PN 6276840000
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
HASBRO.COM
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1- 800-327- 8264
SURFACE WASH ONLY
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including any interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
Loading...