Page 1
AGE 4+
07001
Thank you for purchasing this LITE-BRITE unit!
Requires 2 "C" alkaline batteries (not included). Phillips screwdriver
required (not included) for battery installation.
© 2003 Hasbro. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
07001 P/N 6296790000
TTOO RREEPPLLAACCEE TTHHEE LLIIGGHHTT BBUULLBB
PR6 bulb required.
Use a Phillips screwdriver to loosen 4 screws in back panel. Remove back
panel. Turn unit over, remove screw from bulb cover and remove cover.
Pull out old light bulb and replace with a new PR6 bulb. Refasten bulb
cover, tighten bulb cover screw, then tighten screws to secure back panel.
®
LITEBRITE.COM
LITEBRITE.COM
FOR NEW PRODUCTS AND OFFERS
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-327-8264
WARNING:
CHOKING HAZARD-Small parts.
Not for children under 4 years
.
Page 2
TTOO IINNSSTTAALLLL BBAATTTTEERRIIEESS
Using Phillips screwdriver, loosen screw in battery compartment cover
(screw stays attached to cover). Remove cover. Insert 2 "C" alkaline
batteries. Replace cover and tighten screw.
TTOO PPLLAAYY
This portable, fun-filled toy comes with 120 pegs to make all kinds of
designs that light-up. All it takes is your imagination!
•Insert the pegs into the holes to make colorful designs. Be creative!
•Press the button at the bottom of toy to light-up your designes. The
light will stay on for approximately 3 minutes each time you press
the button, then turn off to conserve battery life.
Insert peg
Press to
light up
design!
Store
pegs here
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers' instructions;
2. Do not mix old batteries and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
Loading...