Hasbro 06717 User Manual

Ride2Roll

™

Scooter

Ride2Roll

™

Scooter

OVER 18 months

06717

CAUTION:

This product contains small parts which are necessary for assembly. Prior to
and during assembly of this product, keep small parts out of children's reach. Small parts pose a
choking hazard to children under 3 years.

Thank you for buying this PLAYSKOOL brand product!

MAXIMUM WEIGHT
60 LBS. (27.2 KGS.)

CAUTION:

Always wear protective equipment including helmet, wrist guards, knee pads

and elbow pads (not included). Close-toed shoes or sneakers must be worn.

WARNING:

Adult supervision required. This ride-on toy is not to be used near swimming
pools, on or near hills, roadways or stairways. Shoes must be worn at all times when riding this
toy. Designed for only one rider at a time.

Parts include:
1 base, 1 end piece, 1 vehicle body, 4 wheels, 1 axle,

1 handlebar section, 1 dashboard unit, 1 dashboard
holder, 1 bag of screws, 2 labels.

Adult assembly
required.

ASSEMBLY

BBAASSEE

EENNDD PPIIEECCEE

VVEEHHIICCLLEE

BBOODDYY

DDAASSHHBBOOAARRDD

HHOOLLDDEERR

1. Attach End piece to Base

Fit end piece onto base. From underside of
base, tighten 2 screws into base and end piece.

AAlliiggnn

hhoolleess

AAXXLLEE

LLAARRGGEERR

WWHHEEEELL

SSMMAALLLLEERR

WWHHEEEELL

RROOUUNNDDEEDD SSIIDDEE FFAACCIINNGG OOUUTT

VVEEHHIICCLLEE

BBOODDYY

AAXXLLEE

3. Attach Vehicle Body and Axle to Base

Fit vehicle body onto base (align holes in body with holes in base). Insert axle through holes.
From underside of vehicle, tighten screw into axle and base.

4. Attach Wheels to Vehicle

Note: Be sure rounded side of wheels
face out

when attaching to vehicle.
Snap smaller wheels onto rear of
base. Snap larger wheels onto axle.

2. Attach Dashboard Holder to Vehicle Body

Fit dashboard holder onto vehicle body (align 3
tabs on holder with slots on body). Tighten 6
screws into dashboard holder and vehicle body.

RIDE-ON

SCOOTER

BBAASSEE

LLAATTCCHH

BBAASSEE PPOOSSTT

TTiigghhtteenn SSccrreewwss

HHAANNDDLLEEBBAARR

SSEECCTTIIOONN

5. Attach Handlebar Section

Press latch on vehicle body, slide arm of handlebar section through hole in vehicle body, and
snap handlebar arm into post on base. Tighten 2 screws into base post and handlebar arm.

6. Attach Label

NOW YOU’RE READY TO ROLL OR RIDE…YOU DECIDE!
This unique toddler toy offers 2 kinds of vehicle play!

Use it as a ride-on or scooter!

As your child grows steadier on his feet, this toy
easily converts to a child’s first scooter that
encourages balance, coordination and timing.

If the toy is in ride-on mode:

• Remove dashboard unit from handlebar
section by lifting it up.

• Press latch on vehicle body and raise vehicle
body until it locks into place. Be sure the
word “LOCKED” appears on latch.

• Snap clip on unit to post in dashboard
holder. (To remove dashboard unit, lift up
on unit from bottom.)

Now you’re ready to roll!

For growing toddlers, the RIDE2ROLL Scooter is
a foot-to-floor ride-on that offers extra height
and leg room.

If the toy is in scooter mode:

• Push latch on vehicle body downward and
bring vehicle body down until it locks into
place. Be sure the word “LOCKED” appears
on latch.

• Slide the clip on the dashboard unit into slot
in the center of handlebar section.

Now you’re ready to ride!

L

O

C

K

E

D

RRIIDDEE--OONN

DDAASSHHBBOOAARRDD

RROOLLLL--OONN

DDAASSHHBBOOAARRDD

PPuullll oouutt ttoo CCoonnvveerrtt ttoo

SSCCOOOOTT MMOODDEE

PPuusshh DDoowwnnwwaarrdd ttoo CCoonnvveerrtt

ttoo RRIIDDEE--OONN MMOODDEE

© 2003 Hasbro, Inc. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
U.S. Patent Pending.
06717 P/N 6293990000

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Consult the dealer or an experienced radio/TV technician for help.

TO REPLACE BATTERIES

Use a Phillips/cross head
screwdriver to loosen
screw in battery
compartment door
(screw remains attached
to door). Remove door.
Remove and discard old
batteries. Insert 3 x

1.5 V "AAA" or LR03-size
batteries. Alkaline
batteries recommended.
Replace door and
tighten screw.

PLAY FEATURES

Flashing lights, happy songs, and great vehicles sounds
help keep the fun in high gear – in either mode!

TTuurrnn tthhee kkeeyy ssttaarrtt tthhee

eennggiinnee ssoouunndd!!

PPllaayyss 55 ddiiffffeerreenntt
cchhiillddrreenn’’ss ssoonnggss!!

PPeerrffeecctt ffoorr iinnddoooorr oorr

oouuttddoooorr ffuunn!!

TTuurrnn tthhee ““ttuurrnn ssiiggnnaall””

lleevveerr ffoorr ssoouunndd eeffffeeccttss!!

EEaassyy--ggrriipp hhaannddlleebbaarrss!!

PPrreessss

bbuuttttoonn ffoorr

hhoorrnn

ssoouunndd aanndd

mmuussiicc!!

DDAASSHHBBOOAARRDD

CAUTION:
TO AVOID BATTERY LEAKAGE

1. As with all small batteries, the batteries
used with this toy should be kept away
from small children who still put things in
their mouths. If they are swallowed,
promptly see a doctor and, in the U.S.,
have the doctor phone [phone]
collect, or, in Canada, have the doctor call
your provincial Poison Control Centre.

2. Make sure the batteries are inserted
correctly and always follow the toy and
battery manufacturers' instructions;

3. Do not mix old batteries and new batteries
or alkaline, standard (carbon zinc) or
rechargeable (nickel-cadmium) batteries.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert them
correctly by matching the + and – polarity
markings.

2. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.

3. Remove exhausted or dead batteries from the
product.

4. Remove batteries if product is not to be played with
for a long time.

5. Do not short-circuit the supply terminals.

6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and
back on again or removing and re-inserting
batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with
any other types of battery. Always remove from the
product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.

PLAYSKOOL.COM

PLAYSKOOL.COM

FOR NEW PRODUCTS AND OFFERS

FOR NEW PRODUCTS AND OFFERS

Questions? Call: 1-800-PLAYSKL