Hasbro 05545 User Manual

OVER 9 months - 36 months

05545

Step Start Walk ‘n Ride™

Step Start Walk ‘n Ride

™

WARNING:

CAUTION:

Adult supervision required. This ride-on toy is not to be used near swimming
pools, on or near hills, roadways or stairways. Shoes must be worn at all
times when riding this toy. Designed for only one rider at a time.

This product contains small parts which are necessary for assembly. Prior to
and during assembly of this product, keep small parts out of children's reach.
Small parts pose a choking hazard to children under 3 years.

ADULT ASSEMBLY AND PHILLIPS/CROSS HEAD SCREWDRIVER (NOT INCLUDED)
REQUIRED.

MAXIMUM WEIGHT 42 LBS. (19 KGS.)
Parts include: body/chassis, 4 wheels, front handle, rear handle, handle retainer, dial,

roller, spinner (2 pieces), antenna, gear shift, 4 plain #6 screws, 1 #6 screw with
attached washer, and instructions.

ASSEMBLY:

11.. AAttttaacchh WWhheeeellss

Tip body/chassis on its side. Snap wheel onto axle,
with flat side of wheel against chassis. Repeat for
remaining 3 wheels.

22.. AAsssseemmbbllee HHaannddlleess

To snap front and rear handles together: Place rear
handle upside down on flat surface. Holding front
handle with back facing rear handle and perpendicular
to rear handle, snap posts on front handle into holes in
rear handle.

33.. AAttttaacchh HHaannddllee AAsssseemmbbllyy ttoo BBooddyy

Lift body and remove cardboard insert.

Turn body/chassis on its side. Insert front handle
through slot in body.

WHEEL

CHASSIS

FRONT HANDLE

REAR HANDLE

BODY

CARD­BOARD
INSERT

FRONT
HANDLE

SLOT

Fit axle on rear handle into ridges in underside of body.
Place handle retainer over axle (retainer fits only one
way). Using the 4 plain #6 screws and Phillips/cross
head screwdriver, attach retainer to body.

NOTE: If body is locked closed, see back panel for
conversion instructions.

AXLE

RIDGES

SCREWS

HANDLE
RETAINER