Page 1
4 x 10-inch plus CD Horn Aluminum Drive
Bass Enclosure
P R O F E S S I O N A L S E R I E S
Page 2
4200 Introduction and Features
Congratulations on purchasing the 4200 bass enclosure by Hartke! The Hartke
well as a description of its front and rear panels, step-by-step instructions for its
Page 3
the total impedance is cut in half and when two speakers are wire in “Series” the total
impedance (many audio guys used the made up word “ohmage”, however the
There is a minimum safe impedance so be sure to check the manufacturerʼs
through the backline, or enhance snap-
you can set the HIGH FREQUENCY
to the PAD position, which will reduce
the compression driver output by 3dB.
the HIGH FREQUENCY control switch
with your amplifier.
Hartke Systems
Distributed Exclusively by
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 2000
200 WATTS
8
�
= 120 WATTS
4
�
= 200 WATTS
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.
ASSEMBLED IN R.O.K.
SERIAL NUMBER
115
~ AC INPUT
115V/230V 50/60Hz
FUSE
5A/250V, 180W (115V)
2.5A/250V, 450W (230V)
SPEAKER OUTPUTS
8
�
8
�
ON OFF
HPF
EFFECT
SEND
RETUIRN
Page 4
Throat, 34 mm Titanium
Width: 24" (60.96 cm)
Depth: 18" (45.42 cm)
www.samsontech.com
Loading...