Harman HKVW6 Users Manual

Harman/Kardon Subwoofer VW6
Quick Start Guide

This product (Product name :Subwoofer, Model:VW6) is used in conjunction with Hisense TV,

VW6 connect with Hisense TV via the 5.8G Wireless module. Hisense TV and this Subwoofer

should have 5.8G wireless module.

1. Power this Subwoofer

2. Turn on Hisense TV at the same time, you should set up Hisense TV to enter pairing mode.

3. The Subwoofer has a pair button with a LED indication for wireless connection.

To show status of the wireless connection, the status LED behavior shall like below：

1) White, flash quickly：enter the Wireless Paring state，wait for the new TX link.

2) White, flash slowly： Back to link, try to link the recently connected TX

3) White color light：Wireless Connection

4) Button：short press the pair button on subwoofer to make it enter the Wireless Paring

state.

Product Specification

Subwoofer Output

Operating Temperature ：0℃ - 45℃

5.8G Wireless Frequency Range：5743-5840MHz

For CE

Hereby, HARMAN INTERNATIONAL INDUSTRIES, INCORPORATED , declares that this Subwoofer is
in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

Federal Communication Commission Interference Statement

Caution: changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

For Products That Transmit RF Energy:

FCC AND IC INFORMATION FOR USERS

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired operation.