Harman HKOMNI10 User Manual

HK OMNI 10

What’s in the box

Buttons

Quick Start Guide

Guide de demarrage rapide

Connections

WPS

LED Status LED Behaviors

Out of the box (Restore Factory Setting)

Slash - White blinking Ring - Oﬀ

APP

H/K Connect

Setup and Control your Harman Kardon wireless system with the required HK Connect app.

Bluetooth®

Full owners manual

harmankardon.com/HK Omni10

AUX input source

AUX

HK OMNI 10

LED Status LED Behaviors

Bluetooth® paring mode

Bluetooth® reconnecting

Bluetooth® connected, no streaming

Bluetooth® connected, streaming

LED Status LED Behaviors

Aux active

Inactive

Slash - Blue blinking Ring - Blue blinking Slash - Blue blinking Ring - Oﬀ

Slash - Solid Blue Ring - Oﬀ

Slash - Solid Blue Ring - Solid Blue

Slash - Solid White Ring - Solid Green

Slash - Solid White Ring - Oﬀ

Multi-room music streaming

Party Mode

LED Status LED Behaviors

Network streaming

Source switching

LED Status LED Behaviors

Party Mode

Slash - Solid White Ring - Solid White

Ring - Multicolor blinking

Single button Play / Stop functionality

Mute

LED Status LED Behaviors

FPO

FCC Information and Copyright

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi si on rece pt i on , whi ch can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.