IMPORTANT SAFETY INSTRUCTIONS
For All Products:
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings.
Install this apparatus in accordance with
the manufacturer’s instructions.
8. Do not install this apparatus near any heat
sources such as radiators, heat registers,
stoves or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of
the polarized or grounding-type plug. A
polarized plug has two blades with one
wider than the other. A grounding-type
plug has two blades and a third grounding
prong. The wide blade or the third prong
is provided for your safety. If the provided
plug does not fit into your outlet, consult an
electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked
on or pinched, particularly at plugs,
convenience receptacles and the point
where they exit from the apparatus.
11. Use only attachments/accessories specified
by the manufacturer.
12. Use only with the cart, stand,
tripod, bracket or table
specified by the manufacturer
or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods
of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as when the power-supply cord or
plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, or
the apparatus has been exposed to rain or
moisture, does not operate normally or has
been dropped.
15. Do not expose this apparatus to dripping or
splashing, and ensure that no objects filled
with liquids, such as vases, are placed on
the apparatus.
16. To disconnect this apparatus from the AC
mains completely, disconnect the powersupply cord plug from the AC receptacle.
17. The mains plug of the power-supply cord
shall remain readily operable.
18. Do not expose batteries to excessive heat
such as sunshine, fire or the like.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THE LIGHTNING FLASH WITH AN ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED “DANGEROUS
VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE
THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO
PERSONS.
THE EXCLAMATION POINT WITHIN AN
EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE LITERATURE
ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
FCC AND IC STATEMENT FOR
USERS (USA AND CANADA
ONLY)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by HARMAN could void the user’s authority to operate the equipment.
For Products That Transmit RF
Energy:
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and
Industry Canada license-exempt RSS 210. Operation is
subject to the following two conditions: (1) This device
may not cause harmful interference; and (2) this device
must accept any interference received, including interference that may cause undesired operation.
-
For Products with Radio Receivers That Can Use an External Antenna (USA ONLY):
CATV (Cable TV) or Antenna Grounding
If an outside antenna or cable system is connected to
this product, be certain that it is grounded so as to provide some protection against voltage surges and static
charges. Section 810 of the National Electrical Code
(NEC), ANSI/NFPA No. 70-1984, provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes
and requirements of the grounding electrode.
Note to CATV System Installer:
This reminder is provided to call the CATV (cable TV)
system installer’s attention to article 820-40 of the NEC,
which provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the grounding system of the building, as close
to the point of cable entry as possible.
IMPORTANT SAFETY INSTRUCTIONS
For CD/DVD/Blu-ray Disc™
Players:
Caution:
This product uses a laser system. To prevent direct
exposure to the laser beam, do not open the cabinet
enclosure or defeat any of the safety mechanisms
provided for your protection. DO NOT STARE INTO THE
LASER BEAM. To ensure proper use of this product, please
read the owner’s manual carefully and retain it for future
use. Should the unit require maintenance or repair, please
contact your local Harman Kardon service center. Refer
servicing to qualified personnel only.
FOR ALL EU COUNTRIES:
For products that include audio out
Prevention of hearing loss
Caution: Permanent hearing loss may occur if earphones
or headphones are used at high volume for prolonged
periods of time.
For France, the products have been tested to comply with
the Sound Pressure Level requirement laid down in the
applicable NF EN50332-1:2000 and/or EN50332-2:2003
standards as required by French Article L.5232-1.
Note: To prevent possible hearing damage, do not listen at
high volume levels for long periods.
WEEE Notice
The Directive on Waste Electrical and Electronic
Equipment (WEEE), which entered into force as European
law on 13th February 2003, resulted in a major change in
the treatment of electrical equipment at end-of-life.
The purpose of this Directive is, as a first priority, the
prevention of WEEE, and in addition, to promote the reuse,
recycling and other forms of recovery of such wastes so
as to reduce disposal.
The WEEE logo on the product or on its box indicating
collection for electrical and electronic equipment consists
of the crossed-out wheeled bin, as shown below.
This product must not be disposed of or dumped with your
other household waste. You are liable to dispose of all your
electronic or electrical waste equipment by relocating
over to the specified collection point for recycling of such
hazardous waste. Isolated collection and proper recovery
of your electronic and electrical waste equipment at the
time of disposal will allow us to help conserving natural
resources. Moreover, proper recycling of the electronic
and electrical waste equipment will ensure safety of
human health and environment. For more information
about electronic and electrical waste equipment disposal,
recovery, and collection points, please contact your local
city center, household waste disposal service, shop from
where you purchased the equipment, or manufacturer of
the equipment.
RoHS Compliance
This product is in compliance with Directive 2011/65/EU
of the European Parliament and of the Council of 8 June
2011 on the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
For Products That Include Batteries
EU Batteries Directive 2006/66/EC
A new battery directive 2006/66/EC on Battery and
Accumulator replacing directive entered into force on the
26th September 2008. The directive applies to all types
of batteries and accumulators (AA, AAA, button cells, lead
acid, rechargeable packs) including those incorporated
into appliances except for military, medical and power
tool applications.
The directive sets out rules for collection, treatment,
recycling and disposal of batteries, and aims to
prohibit certain hazardous substances and to improve
environmental performance of batteries and all operators
in the supply chain.
Instructions for Users on Removal, Recycling and Disposal
of Used Batteries
To remove the batteries from your equipment or remote
control, reverse the procedure described in the owner’s
manual for inserting batteries.
For products with a built-in battery that lasts for the
lifetime of the product, removal may not be possible
for the user. In this case, recycling or recovery centers
handle the dismantling of the product and the removal
of the battery. If, for any reason, it becomes necessary to
replace such a battery, this procedure must be performed
by authorized service centers.
In the European Union and other locations, it is illegal to
dispose of any battery with household trash. All batteries
must be disposed of in an environmentally sound
manner. Contact your local waste-management officials
for information regarding the environmentally sound
collection, recycling and disposal of used batteries.
WARNING: Danger of explosion if battery is incorrectly
replaced. To reduce risk of fire or burns, don’t
disassemble, crush, puncture, short external contacts,
expose to temperature above 60°C (140°F), or dispose
of in fire or water. Replace only with specified batteries.
The symbol indicating ‘separate collection’ for all batteries
and accumulators shall be the crossed-out wheeled bin
shown below:
In case of batteries, accumulators and button cells
containing more than 0.0005 % mercury, more than 0.002
% cadmium or more than 0.004 % lead, shall be marked
with the chemical symbol for the metal concerned: Hg,
Cd or Pb respectively. Please Refer to the below symbol:
For All Products Except Those with
Wireless Operation:
HARMAN International hereby declares that this equipment
is in compliance with the EMC 2004/108/EC Directive,
LVD 2006/95/EC Directive, ErP 2009/125/EC Directive and
RoHS 2011/65/EU Directive. The declaration of conformity
may be consulted in the support section of our Web site,
accessible from www.harmankardon.com.
For All Products with Wireless
Operation:
HARMAN International hereby declares that this equipment
is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC, ErP
2009/125/EC Directive and RoHS 2011/65/EU Directive
The declaration of conformity may be consulted in
the support section of our Web site, accessible from
www.harmankardon.com.
HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
516.255.4545 (USA only)
© 2012 HARMAN International Industries, Incorporated. All rights reserved.
Harman Kardon is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries.
Blu-ray Disc is a trademark of the Blu-ray Disc Association. Features, specifications and appearance are subject to change without notice. www.harmankardon.com