Harley Benton HB-10G User Manual

User manual
HB-10G Guitar Amplifier

PRECAUTIONS

WARNING:
This appliance must be earthed. Please check that the supply
voltage details given on the rating label (located on the rear
panel) are in accordance with your electricity supply.

INSTRUCTIONS FOR USE:

- Plug the mains lead into a suitable power socket.

- Connect your guitar/bass to the input socket of the amplifier

- Turn the volume control to the left position and the EQ
controls to the middle.

- Power on the amplifier.

- Adjust the volume level with the equivalent volume control to
your desired level.

WARNINGS:

If, after you have followed the instructions outlined above, your
amplifier fails to function, please contact your local distributor.

Under no circumstances remove the rear panel of the amplifier.

Electrical appliances must never be used where there is a
danger of water splashing or dripping onto the unit.

Your attention is drawn to the instructions printed on the notice
attached to the back of the amplifier.

Exposure to extremely high noise level may cause a permanent
hear loss. Individuals vary considerably to noise induced hearing
loss but nearly everyone will lose some hearing if exposed to
sufficiently intense noise for a prolonged time.

© 2004 Musikhaus Thomann - 96138 Burgebrach.

R - 281204 KR

Contact:
Musikhaus Thomann
Treppendorf 30
96138 Burgebrach - Germany
Phone.: [phone]
Fax: [phone]
Web: www.thomann.de
E-mail: [e-mail]

Front Panel: Back Panel:

1. Overdrive: This push button switches between the clean

and overdrive channel.

2. Input: This is an instrument input for plugging in

virtually anything. You my plug in a guitar
(bass or lead), keyboard, CD-Player or any
other pre-amplified signal.

3. Gain: This is the distortion intensity control for the

overdrive channel.

4. Tone: Die Klangregelung beeinflusst den Bereich

zwischen 250Hz und 2kHz.

5. Volume: This is the overall level control.

6. Headphones: Inserting a headphone jack will disconnect

internal speaker for quiet practicing.

7. Power: Power Switch

1. AC Line Cord

RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK

DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.

C AUTION :

230VAC~ 50Hz

INPUT POWER

20W MAX

Technichal Specifications:

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

CAUTION: Chassis surface hot.

WARNING: To reduce the risk of fire or electric shock,

do not expose this equipment to rain or moisture.

AVIS: Risque de choc electricque ne pas ouvrir.

ATTENTION: Superficie de chassis chaude.

10

10

100 10 0

0 10

0 10 0

0 10 0

100

100

12W RMS @ 4 ohms (Overdrive)

8W RMS @ 4 ohms (Clean)
Frequency Response 80Hz - 10kHz
THD 0,5% (Clean)
S/N ratio 75dB
Input Impedance 220k Ohm
Power Consumption 20VA (max.)
Maximum Input Level 0.7Vrms
Dimensions (HxWxD) 280mm x 275mm x 150mm
Weight 4,5kg

Rated Power