
INSTALLATION SHEET
IMPORTANT ADDITION TO
Norseman and Sta-Lok Instructions
N15W24983 Bluemound Rd. • Pewaukee, WI 53072 U.S.A.
Telephone: (262) 691-3320 • Fax: (262) 701-5780
Web: www.harken.com • Email: harken@harken.com
Important–You Must Install the Stainless Steel Washer!
Norseman and Sta-Lok® studs are
packaged with a stainless steel washer. This washer must be placed on
the wire before the Norseman or
®
Sta-Lok
wire and the stud assembled.
The washer will ride loosely on the
wire above the top of the Norseman/
Sta-Lok
foils from slipping down over the
top of the fitting in the event the
torque tube clamp becomes loose.
You must use the washer. If the
washer is not used and the foils
slip down, they may unthread the
Norseman/Sta-Lok
parting the headstay.
nosepiece is put on the
®
stud and will prevent the
®
terminal thus

®
is a registered trademark of Sta-Lok Terminals, Ltd.
Sta-Lok
Maintenance
Harken equipment is designed for minimal maintenance, but some maintenance is
required to give the best service and to comply with the Harken limited
warranty.
In general, the most important aspect of maintenance is to keep your equipment
clean by frequently flushing with freshwater.
In corrosive atmospheres, stainless parts may show discoloration around holes,
rivets and screws. This is not serious and may be removed with a fine abrasive.
Important! Exposure to some teak cleaners and other caustic solutions can result
in discoloration of part and is not covered under the Harken warranty.
Warranty
For additional safety, maintenance and warranty information see www.harken.com/
manuals or the Harken® catalog.
Printed in USA. 4411 12/13