Harken 724 User Manual

INSTRUCTION SHEET

Clear Plastic Washers

Clear Plastic Washers

Deck Organizers

ESP: 6052, 6053, 6054, 6055, 6066, 6067, 6071, 6075, 6102, 6103, 6104

N15W24983 Bluemound Rd., Pewaukee, WI 53072-4974 USA

Strictly follow all instructions to avoid an accident, damage to your
vessel, personal injury or death. See www.harken.com/manuals
for additional safety information.

Use stainless steel fasteners in all mounting holes using backing plates,
washers and locknuts. Deck or mounting surface must solid, designed
for block load. Consult with builder.

724, 725, 726, 1867, 1868

Tel: [phone], Fax: [phone]

Web: www.harken.com, Email: [e-mail]

Fasteners, Deck Strength

Install Clear Plastic Washer Isolators

You must install the enclosed clear plastic washers between the stainless steel
washers and the aluminum top plate to prevent dissimilar metal corrosion.

Failure to install washers will void Harken warranty.

DO NOT OVERTIGHTEN—ORGANIZERS/FOOTBLOCKS!

CORRECT INCORRECT

Tighten wrist tight (10 ft-lb/14 N-m)

Do not use power drivers.

Tighten bolts only wrist tight (10 ft-lb/14 N-m) to remove play between
block and deck. Do not use power drivers. Overtightening will permanently

damage organizer and cause sheaves to bind.

Maintenance

Harken equipment requires minimal maintenance, but some is required to give the best
service and to comply with Harken's limited warranty.

It is important to keep equipment clean by frequent flushing with fresh water. In
corrosive atmospheres, stainless parts may show discoloration around holes, rivets and
screws. This is not serious and may be removed with a fine abrasive.

Flush blocks thoroughly with fresh water. Periodically, disassemble the blocks and clean
with detergent and fresh water. Lubrication is not required.

Clear plastic washers should always be used between stainless fasteners and aluminum
sideplates. Stainless fasteners which pass through aluminum blocks should be coated
with an antiseize compound.

Locking nuts should not be used after being removed three times. When replacing
shackles and fasteners, use Harken parts to maintain the proper strength.

IMPORTANT! Exposure to some teak cleaners and other caustic solutions can
result in discoloration of part and is not covered under the Harken warranty.

Warranty

For additional safety, maintenance and warranty information see www.harken.com/
manuals or the Harken

®

catalog.

Printed in USA. 4947 01/14