INSTALLATION SHEET
062 Handhold
Telephone: (262) 691-3320 • Fax: (262) 691-3008 • Web: http://www.harken.com • Email: harken@harken.com
You Must Purchase: Five (5) #10 or 5 mm stainless steel sheet metal, machine, or wood flathead
3
screws.
Only drill spigots you wish to drain. Use 1/8" or 3 mm drill to ream out drain spigots. Attach
purchased plastic tubing so handhold drains to bilge. If you use multiple handholds, connect
spigots in a series so that only one long tube is needed to drain to bilge.
/16" (4mm) plastic tubing to drain to bilge (optional).
N15W24983 Bluemound Rd., Pewaukee, WI 53072-4974 USA
You Must Purchase
Using Drain Spigots
TIP: To prevent leakage
at screws, use a pocket
knife to slightly bevel/
countersink the top of
deck screw hole to allow
sealant to mass around
screw top.
Slightly
Bevel
Cutout Size
47/16" X 13/4"
(113 mm X 44 mm)
Install Handhold
1. Cut out template and use to draw a pattern for cutting opening.
2. Use handhold to mark hole position.
3. For self-tapping sheet metal or wood screws, drill 5 holes using 1/8", 9/63" or 3.5mm drill.
For machine screws, drill 5 holes using 3/16" or 5 mm holes.
4. Apply high quality marine sealant around outer rim of handhold and inside screw holes.
5. Secure handhold by tightening screws or nuts.
Maintenance
Harken equipment requires minimal maintenance, but some is required to give the best service and to comply with
Harken's limited warranty. It is important to keep equipment clean by frequent flushing with fresh water.
Warranty
®
For additional safety, maintenance and warranty information see www.harken.com/manuals or the Harken
Printed in USA. 4402 11/13
catalog.
Loading...