Harken 475 User Manual
INSTRUCTION SHEET
Wire Fairlead Cam Kits
475/298
N15W24983 Bluemound Rd, Pewaukee, WI 53072-4974
Telephone: (262) 691-3320 • Fax: (262) 701-5780
Web: www.harken.com • E-mail: harken@harken.com
Part
No.
150
468
Micro
365
471
Micro
FH=Flathead TH=Trusshead
475 Micro Wire Fairlead — Fits 468/471 Cams
Wire fairlead places fairlead ahead of cam.
Holds line at cleat when not in use.
1. Place wire fairlead in base so channel
faces down.
2. Remove thin red cam base on cleat.
3. Place cam cleat on top of fairlead base
and mount cleat. See cam installation
instructions.
Fasteners
Size Spacing
Cam-Matic
#10 FH
5mm FH
#8 TH
4mm TH
#10 FH
5mm FH
#8 TH
4mm TH
®
38mm
1
27mm
Carbo-Cams
38mm
1
27mm
Cam Cleats
1
1
1
1
1
1
/2"
/16"
/2"
/16"
Min
Line Ø
1
/8"
3mm
3
/32"
®
2mm
1
/8"
3mm
1
/8"
3mm
Max
Line Ø
1
/2"
12mm
1
/4"
6mm
3
/8"
10mm
1
/4"
6mm
298 Wire Fairlead — Fits 150/365 Cams
Wire fairlead places fairlead ahead of cam.
Holds line at cleat when not in use.
1. Place wire fairlead in its base so channel
and beveled bosses face up.
2. Sandwich fairlead legs between fairlead
base and cleat.
Thin red plastic cam base must remain
on cleat.
3. Place cam cleat on top of fairlead base
and mount cleat. See cam installation
instructions.
Additional information:
www.harken.com\manuals
Maintenance
Harken equipment requires minimal maintenance, but some is required to give the best
service and to comply with Harken's limited warranty.
It is important to keep equipment clean by frequent flushing with fresh water. In
corrosive atmospheres, stainless parts may show discoloration around holes, rivets and
screws. This is not serious and may be removed with a fine abrasive.
IMPORTANT! Exposure to some teak cleaners and other caustic solutions can
result in discoloration of part and is not covered under the Harken warranty.
Warranty
For additional safety, maintenance and warranty information see www.harken.com/
manuals or the Harken
®
catalog.
Printed in USA. 4538 04/14
Loading...