Harken 1825 User Manual

INSTALLATION SHEET

Battcar with SDA Fitting

1825, 1826, 1827, 1825HL, 1826HL, 1827HL

N15W24983 Bluemound Rd • Pewaukee, WI 53072-4974 USA.

SDA fitting must be modified to allow a 105°

Tel: [phone] • Fax: [phone]

Web: harken.com • Email: [e-mail]

rotation on both sides.

105°

Modify SDA fitting here to remove the
shaded area to allow fitting to rotate 105°.

105°

Inspect

Frequently inspect shackles and control block fittings for signs of fatigue and replace as necessary. Make sure every
installation includes Harken track end stops. Arrange control tackle so cars do not hit end stops under load.

Maintenance

Traveler Cars: Clean by frequently flushing with fresh water. Periodically clean car by squirting a detergent/

water solution into center openings. Roll car back and forth to distribute evenly then flush bearings with
fresh water.

Do not use spray lubricants because ball bearings may skid not roll. Apply one to two drops of McLube
OneDrop™ to ball contact surfaces of track. Roll car back and forth through OneDrop™ several times
to distribute onto bearings. Wipe remaining OneDrop

™

off track. OneDrop™ is preferred but you can

®

also use one to two drops of a light machine oil. Too much oil attracts dirt.

Track: Clean with detergent and water.
Important! Exposure to some teak cleaners and other caustic solutions can result in discoloration of part and is

not covered under the Harken warranty.

Warranty

®

For additional safety, maintenance and warranty information see www.harken.com/manuals or the Harken

Printed in USA 4541 11/13

catalog.