Harken 144 User Manual
INSTALLATION SHEET
Cam Swivel Bases
144, 205, 216, 360, 361, 402, 403, 1574
N15W24983 Bluemound Rd. • Pewaukee, WI 53072 USA
Tel: +1 (262) 691-3320 • Fax: +1 (262) 701-5780
Web: harken.com • Email: harken@harken.com
WARNING! Strictly follow all instructions to avoid an
accident, damage to your vessel, personal injury or death.
See www.harken.com/manuals for additional safety information.
WARNING! To achieve maximum working load of cam swivel base,
mount using screws (listed below), washers and locknuts in all four
(4) holes.
Part
144
360
205
216
361
402 #10 (5 mm)
403 #10 (5mm)
1574 1/4" (6 mm) 1
The swivel arm has a small amount of movement between arm and base.
Control movement by tightening four mounting screws until swivel begins to
bind. Then back screws off. Leave enough tension to slow arm rotation slightly.
Screw ØScrew Spacing
No.
#10 (5 mm)
#10 (5 mm)
(square pattern)
3
/4" (19 mm)
3
/4" (19 mm)
3
/4" (19 mm) 57 mm Carbo® Air® Blocks, 397, 2634
3
/4" (19 mm) 57 mm Carbo® Air® Blocks, 397, 399, 2634
1
/6" (27 mm) Midrange, Hexaratchet® Blocks
2.25", 3.00" Light Duty Hexaratchet® ,
57 mm, 75 mm Carbo® Air® Blocks, inc.
Big Bullet, 2.25", Little Hexaratchet
Use Base with
These Blocks
Ratchet and Ratchamatic® Blocks
57 mm Carbo® Air® Blocks
Adjust Swivel Arm Rotation
(See drawing on reverse side)
®
,
Maintenance
Harken equipment requires minimal maintenance, but some is required to give the best
service and to comply with Harken's limited warranty.
It is important to keep equipment clean by frequently flushing with fresh water. In
corrosive atmospheres, stainless parts may show discoloration around holes, rivets
and screws. This is not serious and may be removed with a fine abrasive.
With the exception of winches, do not use grease unless specifically recommended in
the instruction sheets.
IMPORTANT! Exposure to some teak cleaners and other caustic solutions can
result in discoloration of part and is not covered under the Harken warranty.
Warranty
For additional safety, maintenance and warranty information see www.harken.com/
manuals or the Harken® catalog.
Printed in USA 4401 04/14
Loading...