TIPOUT TRAY INSTALLATION INSTRUCTIONS
This literature contains all the information you need to install your
Tipout Tray.
*IMPORTANT: Before you begin, familiarize yourself with the
kit contents, identify all parts, read through this instruction
information, and have the necessary tools on hand to get
started.
TOOLS REQUIRED:
3/32” Drill Bit
Electric Hand Drill
#2 Phillips Head Screwdriver
Overlay marked in Step 1 Overlay marked in Step 1
STEP 3
Grab your Tip-Out Tray. Center the Tip-Out Tray in the middle of
the overlay that you marked in STEP 1. Mark the slot centers (see
illustrations). Remove the tray and drill the pilot holes. Screw in
Pan head screws, but not quite all the way so that you can slide
the tray on at the end of STEP 6. By leaving the screws slightly
loose, removal and cleaning of the tray is much easier.
STEP 4
Using a 3/32” drill bit, prepare to drill pilot holes at locations
described below.
*IMPORTANT: Avoid drilling too deep by wrapping masking tape
5/16” from end of bit. This is equal to 5 threads of the Pan Head
Screw. Drill no deeper than front edge of tape.
Now match the hinge to the left side of the frame opening and
mark the hole centers. If opening has a frame edge, mark only
front two hole centers (see illustration samples). Repeat for the
right side of opening and then drill pilot holes at the marked
locations.
Using the Pan head screws, attach the hinge to the panel through
the holes.
STEP 1
Using a sharp soft lead pencil (so you can erase later), trace the
frame perimeter on the false front panel inside. Mark a small “T”
for top panel reference.
STEP 2
Now examine the manner in which your false front panel is attached
to the surrounding cabinet construction. After determining the
best way, carefully remove the false front panel.
www.HardwareResources.com
Overlay marked
in Step 1
Overlay marked
in Step 1
STEP 5
Match the hinge plate to the lower left corner of the panel overlay
outline marked in STEP 1 and mark the slot centers. Slot outlines
must be one on top of the other. Repeat on lower right corner
and drill pilot holes at the 4 locations you just marked (2 lower
left & 2 lower right).
Using the at head screws, install left and then right hinges at pilot
hole locations. Screw hinge at top pilot hole rst. Then screw in
hinge bottom with a second at head screw.
STEP 6
Now erase the overlay outline marked in STEP 1. Replace the tray
on the two remaining Pan head screws. Congratulations, your
Tip-Out Tray is now installed.
Loading...