Harbor Freight Tools Drill Bit Sharpener Product manual

ITEM

To prevent serious injury and/or

property damage:

Wear ANSI-approved safety 1.
goggles and heavy-duty work
gloves during use.

Use only with Drill rated between 2.
2,000 and 3,500 RPM.

Keep guards in place during use.3.
Do not sharpen bits until drill has 4.

run at full speed for two seconds.

5. Read manual of drill used

6. Do not hold Drill during use;
secure in place.

7. Do not bend during use.

8. Do not sharpen bit for longer

than ve seconds.

9. Do not use excessive force.

10.Inspect before use; do not use if
parts loose or damaged.

11.Use for intended purposes.

Place drill (not included) in 1.
bench-mounted jig for stability.

Place drill bit to be sharpened 2.
in correct drill guide (see sizes
marked on handle of Sharpener.)

Secure Sharpener’s input shaft 3.
into the drill chuck. See photo,
below.

Turn on drill and run for at 4.
least two seconds at full RPM
(between 2,000 and 3,5000.).

Slowly push drill bit towards 5.
grinding stone, keeping it in the
guide. Do not use excessive
force.

Between edge sharpening, cool 6.

drill bit in water for ve minutes.

Repeat for each cutting edge (2
edges per drill bit.)

For excessively dulled bit, 7.
process may be done multiple
times to achieve desired results.

98061

DRILL BIT SHARPENER

Drill Bit Guide Sizes:

5/64” to 13/64” / 7/32” to 21/64” / 11/32” to 1/2”

Requires power drill rated between

2,000 and 3,500 RPM

WARNING

INSTRUCTIONS

Grinding Stone

MAINTENANCE: After each use, wipe dirt and debris from the drill guide’s and

08b DO NOT REMOVE. Made in Taiwan.

Input Shaft

lubricate the input shaft with oil.

Drill Guides