Harbor Freight Tools Double Tube Flaring Product manual
Double Tube
Flaring Tool Kit
66534 Flaring Tool Kit
INSTRUCTIONS AND
PRECAUTIONS
Visit our website at:
http://www.harborfreight.com
Read this material before
using this product.
Failure to do so can result
in serious injury.
SAVE THIS MANUAL.
When unpacking, make sure
that the product is intact and
undamaged.
If any parts are missing or broken,
please call 1‑800‑444‑3353
as soon as possible.
Copyright© 2009 by Harbor Freight Tools®.
All rights reserved. No portion of this document
or any artwork contained herein may be
reproduced in any shape or form without the
express written consent of Harbor Freight
Tools. Diagrams within this document may
not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly
from the product described herein. Tools required
for assembly and service may not be included.
For technical questions or replacement
parts, please call 1‑800‑444‑3353.
Manual Revised 11c
Important Safety Information
1. Assemble and use only according
to these instructions. Improper
assembly or use can create hazards.
2. Wear ANSI‑approved safety
goggles and heavy‑duty work
gloves during assembly and use.
3. Keep assembly and use
area clean and well lit.
4. Keep bystanders out of the area
during assembly or use.
5. Do not assemble or use when
tired or when under the inuence
of drugs or medication.
6. This product is not a toy. Do not allow
children to play with or near this item.
7. Use for intended purpose(s) only.
8. Inspect before use; do not
use if parts are damaged.
9. Maintain product labels and
nameplates. These carry important
safety information. If unreadable
or missing, contact Harbor Freight
Tools for a replacement.
Operating Instructions
3. Prepare the tube by making a
clean cut straight across the tube.
Deburr inner and outer edges.
4. Back off the Compression Cone and
the pivoting wing nut and then slide
Yoke (1) over Screen Bar Assembly (2).
Installing the Yoke
5. Place the are connector nut (not
included) over the tube before aring.
6. Insert the prepared tubing into the
proper‑size hole in the Screen Bar.
Allow the end of the tube to protrude.
7. The end of the tube must protrude
above the top of the bar as much
as the height of the shoulder of
the Adapter. On the two smallest
Adapters, the tube protrusion is equal
to the large adapter shoulder.
8. After setting the tubing height, tighten
the Screen Bar Assembly on the tube
by tightening the two Wing Nuts.
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of
this document including all
text under subheadings therein
before set up or use of
this product.
1. This tool is used to create a double
ared end on Copper, Aluminum,
Soft Steel and Brass tubing.
2. You may are tubing from
3/16” to 5/8” in diameter.
Button
Shoulder
Adapters
Page 2For technical questions, please call 1‑800‑444‑3353.SKU 66534
Loading...