Harbor Freight Tools Compact Aluminum Racing Floor Jack Product manual

Table of Contents

Safety ......................................................... 2

Setup .......................................................... 3

Operation .................................................... 4

SAFETY OPERATION MAINTENANCESETUP

This is the safety alert symbol. It is used to alert you to potential personal injury hazards.

IMPORTANT SAFETY INFORMATION

Maintenance ............................................... 5

Parts List and Diagram ............................... 7

Warranty ..................................................... 8

WARNING SYMBOLS AND DEFINITIONS

Obey all safety messages that follow this symbol to avoid possible injury or death.

Indicates a hazardous situation which, if not avoided,

will result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury.

Addresses practices not related to personal injury.

Failure to heed these markings may result in personal injury and/or property damage.

1. Study, understand, and follow all instructions
before operating this device.

2. Do not exceed rated capacity.

3. Use only on hard, level surfaces.

4. Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.

5. Do not move or dolly the vehicle while on the jack.

6. No alterations shall be made to this product.

7. Never work on, under or around a load
supported only by this device.

8. Do not adjust safety valve.

9. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.

10. Keep clear of load while lifting and lowering.

11. Lower load slowly.

12. Apply parking brake and chock
tires before lifting vehicle.

13. Lift vehicle only at manufacturer
recommended locations.

14. Inspect before every use; do not use
if parts are loose or damaged.

15. Do not use for aircraft purposes.

16. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.

17. The brass components of this product contain lead,
a chemical known to the State of California to cause
cancer, birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)

IMPORTANT! Before first use:

Check hydraulic fluid level and fill to 1/4″ below the

fill port as needed - see instructions on page 4.
Thoroughly test the Jack for proper operation. If it
does not work properly, bleed air from its hydraulic
system - see instructions on page 4.

SAVE THESE INSTRUCTIONS.

Page 2 For technical questions, please call 1-888-866-5797. Item 62160

Setup - Before Use:

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages,

refer to Parts List and Assembly Diagram on page 7.

Tool Set Up

Attaching the Handle

1. Attach the Upper Handle to the Lower Handle.

2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.

Functions

Saddle

Lifting Arm

Saddle Pad

SAFETYOPERATIONMAINTENANCE SETUP

3. Tighten the Set Screw.

Handle

Oil Fill Plug

(not shown)

Carry Handle

Cover Screw for

Safety Valve.

Do not open

or adjust.

Handle
Socket

Set Screw

Rear Caster

Screw

Fill Screw

Page 3For technical questions, please call 1-888-866-5797.Item 62160