Harbor Freight Tools 97576 Product manual
ITEM 97576
To prevent serious injury:
Wear ANSI-approved safety goggles and heavy-duty 1.
work gloves during use.
Relieve line pressure before use.2.
Service of air conditioning systems must be done 3.
only by trained and experienced technician.
Technicians opening refrigeration circuit in 4.
automotive air conditioning systems MUST be
certied in refrigerant recovery and recycling
procedures in compliance with section 609 of Clean
Air Act Amendments of 1990.
Inspect before use; do not use if parts loose or 5.
damaged.
Use for intended purposes only.6.
Read vehicle service manual before use.7.
6-PIECE A/C &
FUEL LINE QUICK
DISCONNECT SET
Includes: 7/8”, 3/4”, 5/8” 1/2”, 3/8” and
5/16” Sizes
WARNING
1. Select the correct size connector by matching
tool’s inner lip to diameter of spring or open side of
tting.
2. Slip connector over line with inner lip facing spring
or open line tting. See Fig. A, above. Press inner
lip of connector into line tting until it “clicks” into
place as line releases.
3. Disconnect the line sections. To reconnect, push
line ttings together. See Fig. B, below.
08a SAVE THESE WARNINGS. Made in China.
INSTRUCTIONS:
Fitting
Inner Lip
Figure A
Figure B
Loading...