Harbor Freight Tools 94985 Owner's Manual

Specifications

Overall Dimensions 9" L x 6-3/4" W x 6-3/4" H

Batteries 4 - AA (sold separately)

IMPORTANT SAFETY INFORMATION

Installation Precautions

1. Verify that installation surface has no hidden
utility lines before drilling or driving screws.

2. Wear ANSI-approved safety
goggles during installation.

3. Mount securely before use.

4. Install only according to these instructions.
Improper installation can create hazards.

Use Precautions

1. Keep closed and locked whenever unattended.
RISK OF CHILD ENTRAPMENT AND
SUFFOCATION.
Check inside before closing.
Do not allow children to play with or near safe.
Keep keys and codes away from children.

2. Keep clear of door when closing.

3. Position batteries in proper polarity and
do not install batteries of different types,
charge levels, or capacities together.

4. Use as intended only.

5. Inspect before every use; do not use
if parts are loose or damaged.

6. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

5. Keep installation area clean and well lit.

6. Keep bystanders out of the area during installation.

7. Do not install when tired or when under the
influence of alcohol, drugs or medication.

8. Place the Safe on correct surface.
Only use this Safe on a stable, level, clean and dry
surface that is capable of sustaining the load.

7. Do not store Keys inside of the Safe.

Place the emergency keys in a location
outside of the safe making sure they are
in a secure location that you can find.

8. Warning: The brass components of this
product contain lead, a chemical known
to the State of California to cause birth
defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)

9. The warnings, cautions, and instructions discussed
in this instruction manual cannot cover all possible
conditions and situations that may occur. It must
be understood by the operator that common sense
and caution are factors which cannot be built into
this product, but must be supplied by the operator.

10. The Safe is not fireproof.

NOTE: Harbor Freight Tools is not responsible
for the loss of any property stored within this safe
due to theft, fire, or any other circumstance.

Page 2 For technical questions, please call 1-800-444-3353. Item 94985

Mounting the Safe

1. To mount the Safe to a wall or surface, use
a drill to set the path for each Sheet Metal
Screw. Make certain that the drilling

path is clear and free of obstacles such
as wires, cables and electrical lines.

2. Use wall anchors (not included) as necessary.

3. Insert the Screws (included) through each
drilled hole and into a stud to secure
the Safe to the desired surface.

Page 3For technical questions, please call 1-800-444-3353.Item 94985