Harbor Freight Tools 94137 User Manual

Owner’s Manual & Safety Instructions

Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating,

inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.

2 Pc. Submersible

LED TRAILER LIGHTS

REV 13d

When unpacking, make sure that the product is intact and undamaged. If any parts are missing or broken,

please call 1-800-444-3353 as soon as possible.

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product

described herein. Tools required for assembly and service may not be included.

Visit our website at: http://www.harborfreight.com

Email our technical support at: tech@harborfreight.com

ITEMS 94137 & 61306

Read this material before using this product. Failure to do so can result in serious injury. SAVE THIS MANUAL.

Specifications

Power Source 12 VDC only (Negative Ground Only)

Features

Light Type 18 LEDs Per Light (not serviceable)

Safety Requirements Met

2 Combination Submersible, Class A Stop, Tail, Turn Signals, License Plate Bracket, 4 ft. Trunk Harness and 25 ft. Y-Harness.

DOT, if installed properly

DOT and Federal Vehicle Safety (FMVSS), if installed properly

Page 2 For technical questions, please call 1-800-444-3353. Trailer Lights

Important Safety Information

Installation Precautions

1. Install only according to these instructions. Improper installation can create hazards.

2. Wear ANSI-approved safety goggles and heavy-duty work gloves during installation.

3. Keep installation area clean and well lit.

4. Keep bystanders out of the area during installation.

5. Do not install when tired or when under the influence of drugs or medication.

6. Read all instructions and safety precautions in the vehicle’s manual onto which the Trailer Lights will be installed.

7. Install on negative ground 12VDC systems only.

8. Do not install this product yourself unless you are technically competent

to do so. If necessary, have a qualied

technician install the Trailer Lights.

Use Precautions

9. Use the correct lights and electrical setup for your trailer. If the vehicle is OVER 80" wide, install three additional Red Marker Lights* (not included) onto the rear of the unit to comply with DOT standards.

10. If the towing vehicle has rear turn signals separated from its stop lights, additional hardware and installation procedures will be needed. Contact a qualified technician for guidance.

* Example additional marker light locations:

Mount the three Red Marker Lights to the rear of the vehicle, making sure the Lights are no closer than 6" and no farther away than 12" from each other center to center. After mounting, use wire nut connectors (not included) to connect all three leads together. Then connect to the Brown wire in the back of one Tail Light (either side) provided in this Kit.

1. This product is not a toy. Do not allow children to play with this item.

2. Use as intended only.

3. Inspect before every use; do not use if parts are loose or damaged.

4. Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

Page 3For technical questions, please call 1-800-444-3353.Trailer Lights

+ 5 hidden pages