Harbor Freight Tools 93601 User Manual

®

DUST COLLECTOR

ACCESSORY KIT

93601

ASSEMBLY & OPERATING INSTRUCTIONS

Due to continuing improvement, actual product may differ slightly from product described herein.

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web Site at www.harborfreight.com

Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.

For technical questions and replacement parts please call 1-800-444-3353.

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please

complete the owner’s record below:

Model______________ Serial No._____________ Purchase Date_______________

SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the
entire manual to become familiar with the unit BEFORE you begin assembly.

Technical Specifications

Material: ABS Thermoplastic, low carbon steel clamps, ply vinyl flex hose
Hose Dimensions: (2) 4” diameter x 10’
Also included: (1) Table Saw Hood 12” square, (1) Y Connector, (2) Blast Gates,

(2) Jointer Hoods-6” square, (10) Wire Hose Clamps

Weight: 13 Lbs.

Safety Warnings and Precautions

WARNING: When using product, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.

Read all instructions before using this product!

1. Keep work area clean. Cluttered areas invite injuries.

2. Observe work area conditions. Keep work area well lighted.

3. Store idle equipment. When not in use, the Dust Collector Accessory Kit must be stored in a

safe and dry location to inhibit rust. Always lock up products and keep out of reach of children.

4.

Use the right product for the job. There are certain applications for which the Dust Collector

Accessory Kit was designed. Do not modify the Accessory Kit and do not use this product for a
purpose for which it was not intended.

5. Check for damaged parts. Before using any product, any part that appears damaged should

be carefully checked to determine that it will operate properly and perform its intended function.
Check for any broken or damaged parts and any other conditions that may affect its operation.
Replace or repair damaged or worn parts immediately.

6. Replacement parts and accessories. When servicing, use only identical replacement parts.

Use of any other parts will void the warranty.

7. Do not operate product if under the influence of alcohol or drugs. Read warning labels on

prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there
is any doubt, do not operate the product.

8. Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear a full

face shield if you are producing metal filings and wood chips. Wear an ANSI approved dust
mask or respirator when working around metal, wood, and chemical dusts and mists.

9. Do not place the Hoses in walkways or in any trafficked location. Set up the Dust

Collector Accessory Kit in a location where people or vehicles will not trip or run over the
hoses.

SKU 93601 For technical questions please call 1-800-444-3353. Page 2