Harbor Freight Tools 93198 Product manual

Specifications

Materials Molded Polyethylene Plastic

Bin Interior Dimensions 5" D x 3.5" W

Weight Capacity 5 lb per Bin, 75 lb total for rack

IMPORTANT SAFETY INFORMATION

Assembly Precautions

1. Assemble only according to these instructions.
Improper assembly can create hazards.

2. Wear ANSI-approved safety goggles and
heavy-duty work gloves during assembly.

3. Keep assembly area clean and well lit.

Use Precautions

1. This product is not a toy. Do not allow
children to play with or near this item.

2. Use as intended only.

3. Inspect before every use; do not use
if parts are loose or damaged.

Assembly Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.

1. Attach the right and left Stands (2) to the
Rack (1), using Bolts (7), Washers (6)
and Nuts (8). See Figure A.

Rack (1)

Bolt (7), Washer

(6), Nut (8)

Stand (2)

Figure A

2. Tap the Plugs (5) into each end of
both Stands (2). See Figure A.

3. Click the colored Bins (4-1, 4-2 and 4-3) into place
over the hooks on the Rack (1). See Figure B.

Plug (5)

4. Keep bystanders out of the area during assembly.

5. Do not assemble when tired or when under the
influence of alcohol, drugs or medication.

6. Weight capacity and other product capabilities apply
to properly and completely assembled product only.

4. Do not exceed listed weight capacity, loaded from
bottom up.
Be aware of dynamic loading!
Sudden load movement may briefly create
excess load causing product failure.

5. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.

4. Do not overload the individual Bins,

especially those in the top row. This
could cause the Bin Rack to tip over.

5. After assembly, label each Bin via the Name
Plate Holder (3). (For example: Nut M5,
Washer 5mm, Bolt M5x10, Nails, etc.)

a. Slip the Name Plate Holder off the front of the Bin.

b. Place a label between the Name

Plate Holder’s plastic sleeve.

c. Snap the Name Plate Holder back

in place. See Figure C.

Name Plate

Holder (3)

Red Bin

(4-1)

Blue Bin

(4-3)

Yellow

Bin (4-2)

Rack (1)

Figure C

Figure B

Page 2 For technical questions, please call 1-888-866-5797. Item 93198