Harbor Freight Tools 92588 User Manual

Page 1
MULTI-COLORED, DELTA-WING
KITE
Model
92588
ASSEMBLY INSTRUCTIONS
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury. SAVE THIS MANUAL.
Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Revised Manual 09l
Page 2
SPECIFICATIONS
Kite Type Two line controlled, delta-wing Overall Dimensions 65” Wing span x 32” Long String Length Two @ 98 Feet Long Additional Parts 15” Fiberglass Pole (Qty. 1)
25” Fiberglass Pole (Qty. 2)
5-1/2” Brace (Qty. 2) Material Nylon, Fiberglass Weight .80 lb
NOTE: No replacement parts are available for
this product.
Fly the Kite only during well lit, 2. daylight hours. Do not y the Kite
under poor visibility situations.
Do not allow children under 9 years of 3. age to use. Children 9 and older should only use under adult supervision.
Keep bystanders, children, and 4.
visitors away while ying the Kite.
Distractions can cause you to lose
control. Protect others in the y zone
area.
UNPACKING
When unpacking, make sure all the parts shown in this manual are included. If any parts are missing or broken, please call Harbor Freight Tools at 1-800-444-3353 as soon as possible.
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.
GENERAL SAFETY
PRECAUTIONS
Stay alert. Watch what you are doing, 5.
and use common sense when ying the Kite. Do not y the Kite while tired or under the inuence of drugs,
alcohol, or medication. A moment
of inattention while ying the Kite may
result in serious personal injury.
Do not attempt to catch the Kite while it 6. is in motion.
Fly the Kite in a large, open area free of 7. trees, power lines, and other obstacles.
Never y the Kite near electrical wires,
in the rain, or when lightening is present.
Never y the Kite near buildings, cars, or
busy streets.
Do not overreach. Keep proper 8. footing and balance at all times.
Proper footing and balance enables better control of the kite in unexpected situations.
WARNING!
READ AND UNDERSTAND ALL
INSTRUCTIONS
Failure to follow all instructions listed in
the following pages may result in electric
shock, re, and/or serious injury.
SAVE THESE INSTRUCTIONS
Wear ANSI-approved safety impact 1.
eyeglasses during assembly.
Page 2 For technical questions, please call 1-800-444-3353. SKU 92588
Store out of reach of children. 9.
If damaged, have the Kite serviced 10. before using. Check for loose Tension
Poles, misalignment or binding of parts, damaged String, and any other condition that may affect its proper operation.
Repair service must be performed 11.
only by qualied repair personnel.
Service or maintenance performed by
REV 09l
Page 3
unqualied personnel could result in a
risk of injury.
The warnings, precautions, and 12.
instructions discussed in this manual
cannot cover all possible conditions and
situations that may occur. The operator
must understand that common sense
and caution are factors, which cannot
be built into this product, but must be
supplied by the operator.
Insert a 25” Tension Pole (2) midway 3. through a 5-1/2” Brace (3). Then, repeat this Step for the remaining 25” Tension Pole and 5-1/2” Brace.
Insert one end of the 25” Tension Pole 4. (2) in the Socket located into the rear/ center of the Kite. Then insert the other end of the 25” Tension Pole into a Socket located on the edge toward the rear end of the Kite. Repeat this step for the remaining 25” Tension Pole.
ASSEMBLY INSTRUCTIONS
Unpack, and lay the Kite (bottom side 1.
up) on a at, level surface.
Insert each end of the 15” Tension Pole 2.
(1) into a Socket located on the edge
toward the front end of the Kite.
SOCKET
SOCKET
SOCKET
Insert the end of each 5-1/2” Brace (3) 5. into a Socket located toward the rear.
Tie the String from the String Wheel 6. (4) onto a String Ring (5). Repeat this Step for the remaining String Wheel and String Ring.
15” TENSION POLE (1)
SOCKET
SOCKET
SOCKET
FIGURE A
STRING WHEEL
(4)
25”
TENSION
POLE
(2)
STRING
RING
(5)
STRING
RING
(5)
5-1/2” BRACE (3) SOCKET
25”
TENSION
POLE
(2)
Page 3For technical questions, please call 1-800-444-3353.SKU 92588
Page 4
KITE FLYING TIPS
INSPECTION, MAINTENANCE,
Wind that is too strong or too light is 1.
difcult to y in. A ag or windsock is
handy to help you see the wind. Delta
type kites y well in light to medium
winds (about 6-15 mph). If the Kite sinks
tail rst, there might be too much wind. If
the Kite comes down head rst or spins,
there might be too much wind.
Lay out the Kite and lines completely 2.
before you launch. Lay out the String
Rings (5) so they are balanced on the
right and left side of the Kite. Use at
least 60 feet to 90 feet of string to allow
enough time to react. Make sure the
Strings are even. If one string is shorter,
the Kite will pull on that string and spin in
that direction.
To launch,3. step backwards and pull both
String Wheels (4) to your side. Be sure
to check behind you for obstructions or
hazards before backing up. To control,
pull the left String to make the Kite turn
left. Pull the right String to turn right.
Hold the Strings even to y straight. Try
not to over-control.
AND CLEANING
Before each use, 1. inspect the general
condition of the Kite. Check for broken, cracked, or torn parts, loose or missing parts, and any condition that may affect the proper operation of the product. If a problem occurs, have the problem corrected before further use.
Do not use damaged equipment.
When cleaning, 2. use a clean cloth with
a mild detergent. Do not use solvents. Then, store the Kite in a safe, dry location out of reach of children.
CAUTION! All maintenance, service, 3. or repairs not listed in this manual are
only to be attempted by a qualied
service technician.
The more to the side of the wind the Kite 4.
ies, the less lift and speed it has. When
learning to y, keep the Kite downwind.
As you get better, explore the more
challenging levels of performance. To
land the Kite, real in one of the String
Wheels (4). Once the Kite has landed,
real in the remaining String Wheel.
Page 4 For technical questions, please call 1-800-444-3353. SKU 92588
Loading...