Page 1
®
1 PIECE STAINLESS STEEL
SOLAR GARDEN LIGHT
92151
ASSEMBLY & OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web Site at www.harborfreight.com
Copyright© 2004 by Harbor Freight Tools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions and replacement parts please call 1-800-444-3353.
Page 2
THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please
complete the owner’s record below:
Model
______________ Serial No._____________ Purchase Date_______________
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the
entire manual to become familiar with the unit BEFORE you begin assembly.
Technical Specifications
Construction: High impact plastic, stainless steel with a
polystyrene lens and cover
Hood Dimensions: 6-3/8” diameter x 1-1/2” High
Lens: 6” diameter x 3-1/4” height
Mounting Pole: 1-1/4” diameter x 11-11/16” length
Stake: 2” x 2” wide, 6-1/4” long
Bulb: 1 white LED (non-replaceable)
Voltage: 2.4V
Power Source: (2) 1.2V AA Ni-Cad rechargeable batteries
Duration of Charge: Works up to 8 hours on a full charge.
Safety Warnings and Precautions
WARNING: When using product, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
1. Keep work area clean. Cluttered areas invite injury.
2. Observe work area conditions. Keep work area well lit. Position the Solar Garden Light in an
unobstructed area that receives sunlight at least six hours a day.
3. Check for damaged parts. Before using any product, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its intended function.
Check for any broken or damaged parts and any other conditions that may affect its operation.
Replace or repair damaged or worn parts immediately. Do not use the Solar Garden Light if
any switch does not turn on and off properly.
4. Replacement parts and accessories. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty.
5. Always check hardware and assembled parts after assembling. All connections should be
tight and hardware tightened.
6. Keep children away. Children must never be allowed in the work area. Do not let them
handle the Solar Garden Light.
SKU 92151 For technical questions, please call 1-800-444-3353. Page 2
Page 3
7. Dress properly. Protective, electrically nonconductive clothes and nonskid footwear are
recommended when working with the Solar Garden Light. Wear restrictive hair covering to
contain long hair.
8. Use eye protection. Always wear ANSI approved impact safety goggles when setting up this
product.
9. Maintain products with care. Keep the Solar Garden Light clean for better and safer
performance. Note: Dust covering the Solar Panel will block out sunlight causing a
decrease or stoppage of efficiency in recharging the batteries. Follow instructions for set
up. Inspect the Solar Garden Light periodically. if damaged, have it repaired by an authorized
technician.
10. Do not overreach. Keep proper footing and balance at all times.
11. Use the right Solar Light for the job. There are certain applications for which this Solar Light
was designed. Do not modify this Solar Garden Light and do not use this Solar Garden Light
for a purpose for which it was not intended.
12. Do not set up the Solar Garden Light if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgement or reflexes are impaired while
taking drugs. If there is any doubt, do not set up the Solar Light.
13. When setting up the Solar Garden Light, make sure it is not in a location where it
becomes a tripping hazard.
WARNING: NiCad batteries must be disposed of properly. Do not incinerate. Batteries may
burst, causing personal injury and/or property damage. Contact your local
hazardous waste disposal authority for proper disposal.
Warning: People with pacemakers should consult with their physician before using this
product; operation of equipment in close proximity to a heart pacemaker could
cause interference or failure of the pacemaker.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking the Stainless Steel Solar Garden Light, check to make sure that all parts are
included (see parts list on page 5). If any parts are missing or broken, please call HARBOR
FREIGHT TOOLS at 1-800-444-3353.
Assembly/ Operation
Your Stainless Steel Solar Garden Light will require some light assembly. The Solar Garden Light
requires special conditions for set up and operation. It is important that you read the entire manual
to become familiar with the product BEFORE you use the Solar Garden Light. Before operating the
Solar Garden Light be sure that you have all parts described in the Parts List and Assembly
Diagram located on the last pages of this manual.
1. The Mounting Pole (3) comes in two pieces. The two pieces are to be joined by a Fitting (7).
Slide and twist the Fitting (7) into the end of one Mounting Pole (3)-see Figure 1.
2. Slide and twist the second Mounting Pole over the Fitting as in Figure 2.
SKU 92151 For technical questions, please call 1-800-444-3353. Page 3
Page 4
Figure 1
Figure 2
Fitting (7)
Fitting (7)
Mounting Pole (3)
Mounting Pole (3)
3. Insert the Stake (4) into the Mounting Pole (3) with the sharp end facing downward-see
Figure 3.
4. Insert the Light (1) down into the Mounting Pole (3)-see Figure 3.
Light (1)
5. Decide where you want to place the Solar Garden
Light. Choose a location that receives full, direct
sunlight a minimum of six hours a day. The location
should not be near nighttime light sources such as
porch lights or streetlights as this will cause the
Mounting Pole (3)
Stake (4)
Figure 3
Solar Garden Light to remain off. Do not locate the
light in a place where it becomes a tripping hazard.
The Solar Garden Light must be inserted into a
ground surface that will hold the Solar Garden Light
in an upright and stable position. Be careful not to damage the Mounting Pole (3) while light is
being set up. The Solar Garden Light is not waterproof and must not be set in water
such as pools or ponds.
6. The Solar Garden Light will need to charge for at least six hours before using it for the
first time.
7. Located on the top of the Solar Garden Light is a panel with a “ON”/”OFF” Button (6)-see
Figure 4. Pressing the On/Off Button (6) will turn the Solar Garden Light on or off. Remove
the Globe (2) and remove the Light (1) from the top. Press the On/Off Button (6) to the “ON”
position.
Figure 4
Globe (2)
SKU 92151 For technical questions, please call 1-800-444-3353. Page 4
On/Off
Button (6)
Page 5
Replacing the Batteries
NOTE: Before performing any maintenance, make sure the “ON”/”OFF” Button (6) is in the “OFF”
position.
1. Located on the plate that holds the Light (1) is a panel-see Figure 5. Press in and pull off
the Battery Cover (8) of the Battery Compartment.
2. Pull out the Batteries (5) and replace with two new rechargeable Ni-Cad Batteries (5).
Caution: Make certain that the batteries are installed with the positive and negative poles
as indicated. Use Ni-Cad Batteries only.
Figure 5
Ni-Cad
Batteries (5)
Battery
Cover (8)
WARNING: NiCad batteries must be disposed of properly. Do not incinerate. Batteries may
burst, causing personal injury and/or property damage. Contact your local
hazardous waste disposal authority for proper disposal.
Parts List
Part # Description Quantity Part # Description Quantity
1 Light 1 6 On/Off Button 1
2 Globe 1 7 Fitting 1
3 Mounting Pole 2 8 Battery Cover 1
4Stake 1
5 Battery 2
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
1
2
5
8
6
3
7
3
4
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
SKU 92151 For technical questions, please call 1-800-444-3353. Page 5
Loading...