Harbor Freight Tools 91621 Owner's Manual

WATCH CASE PRESS

With Nylon Dies

ITEM

91621

Description:

The Watch Press is used to attach the two parts of a watch case together. This is achieved
by pressing the back of the watch case into the front of the watch case.

Instructions:

The Watch Case Press comes with 6 bottom nylon dies and 6 upper nylon dies. There is
a small hole in the center of each die that is press-fitted onto the small steel shaft of the
upper and lower die holders on the Watch Case Press. The first step is to find the correct
size die that matches the face of the watch. Attach that die on the bottom press holder.
Next find the die that matches up with the size of the back of the watch case, then attach
that die to the upper part of the Watch Case Press. Place the watch face down in the
recessed area of the bottom die, then slowly press down of the arm of the Watch Case
Press until the two parts of the watch are completely attached together.

1. Always wear ANSI-approved safety goggles when using this product.

2. Harbor Freight Tools is not responsible for any damage to a watch that may result
while using this product.

3. Keep this tool and other tools out of the reach of children.

4. Keep your hands and fingers away from the dies while you are pressing down on the
arm of the Watch Press.

5. Use this product on a solid flat surface capable of withstanding the weight and force
generated when using the Watch Case Press.

Visit our Web site at http://www.harborfreight.com

For technical questions please call 1-800-444-3353

R

3491 Mission Oaks Blvd., Camarillo, CA 93011