Harbor Freight Tools 90310 User Manual

DUPLEX RABBET &

FILLISTER PLANE

90310

ASSEMBLY AND OPERATING INSTRUCTIONS

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web site at http://www.harborfreight.com

Copyright © 2003 by Harbor Freight Tools®. All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape
or form without the express written consent of Harbor Freight Tools.

For technical questions and replacement parts, please call 1-800-444-3353

Specifications

Overall Dimensions 9-3/4” L x 4-1/8” W x 4-7/8” H
Plane Dimensions 9-3/4” L x 1-1/2” W x 4-3/8” H
Fence Dimensions (2) 1 @ 5-3/8” L x 1/2” H

1 @ 1-7/8” L x 3/8” H
Front Blade 1-1/2” W x 1/2” H
Rear Blade 4-1/16” L x 1-1/2” W x .08” Thick

Save This Manual

You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.

Safety Warnings and Precautions

WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.

Read all instructions before using this tool!

1. Keep work area clean. Cluttered areas invite injuries.

2. Observe work area conditions. Do not use tools in damp or wet locations. Don’t
expose to rain. Keep work area well lighted.

3. Keep children away. Children must never be allowed in the work area. Do not let
them handle tools.

4. Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.

5. Use the right tool for the job. Do not attempt to force a small tool or attachment to
do the work of a larger industrial tool. There are certain applications for which this tool
was designed. It will do the job better and more safely at the rate for which it was
intended. Do not modify this tool and do not use this tool for a purpose for which it
was not intended.

6. Dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically non-conductive clothes and non-skid footwear
are recommended when working. Wear restrictive hair covering to contain long hair.

7. Use eye protection. Always wear ANSI approved impact safety goggles. Wear a full
face shield if you are producing metal filings or wood chips. Wear an ANSI approved
dust mask or respirator when working around metal, wood, and chemical dusts and
mists.

8. Do not overreach. Keep proper footing and balance at all times.

Page 2SKU 90310