Harbor Freight Tools 69520 Owner's Manual
Specifications
Weight Capacity 1,000 lb.
Assembled Dimensions 34-3/4″ L x 31″ W x 36″ H
Face Plate 10-3/16″ W x 6″ H x 7/16″ thick
Wheel Diameter 3″ (x2), 3-1/2″ (x2)
Important Safety Information
Assembly Precautions
1. Assemble only according to these
instructions. Improper assembly
can create hazards.
2. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the
5. Do not assemble when tired
6. Weight capacity and other product
Use Precautions
Failure to heed these instructions may result in
personal injury and/or property damage:
1. Study, understand, and follow all
instructions before operating this device.
2. Do not exceed rated capacity.
Be aware of dynamic loading!
Sudden load movement may
briefly create excess load
causing product failure.
3. Use only on hard, level surfaces.
4. Lock mounting plate rotating
mechanism before applying a load.
5. Assure load is centered and secured
to mounting attachments.
6. Hold Handle while removing the Pin.
7. Wear ANSI-approved safety goggles
8. Do not use for aircraft purposes.
9. Inspect before every use;
10. This product is not a toy. Do not allow
11. Use as intended only.
12. Maintain product labels and nameplates.
area during assembly.
or when under the influence
of drugs or medication.
capabilities apply to properly and
completely assembled product only.
and heavy-duty work gloves during use.
do not use if parts loose or damaged.
children to play with or near this item.
These carry important
safety information. If unreadable
or missing, contact Harbor Freight Tools
for a replacement.
Page 2 For technical questions, please call 1-800-444-3353. Item 69520
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Column (1)
Middle
Beam (17)
Bolt (10)
Figure A: Attach Column to Middle Beam
1. Insert Middle Beam (17) into the
receiver at the base of the Column (1)
and secure with Bolt (10).
Bolt (3)
Bolt (3)
Rear
Beam (4)
Nut (14)
Lock
Washer (13)
Figure B: Attach Front and Rear Beams
Front
Beam (16)
Nut (14)
2. Use Bolts (3), Lock Washers (13), and
Nuts (14) to attach the Front Beam (16)
to the Middle Beam (17).
3. Also, use Bolts (3), Lock Washers (13),
and Nuts (14) to attach
the Rear Beam (4) to the
bottom of the Column (1),
with the wheel brackets on bottom.
Bolt (5)
Nut (11)
Lock
Washer (12)
Washer (21)
Bushing
(23)
Wheel (7)
Caster (15)
Figure C: Attach Wheels and Casters
4. Attach each Caster (15) to the
Front Beam (16) using one Washer (21),
Lock Washer (12), and Nut (11).
5. Insert a Bushing (23) into each
Wheel (7), and place one wheel into
each bracket on the Rear Beam (4)
6. Slide a Wheel (7) onto each
axle at end of Rear Beam (4).
Then secure with a Snap Ring (5).
Page 3For technical questions, please call 1-800-444-3353.Item 69520
Loading...