Harbor Freight Tools 69462 Owner's Manual
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual
near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
Visit our website at: http://www.harborfreight.com
Email our technical support at: tech@harborfreight.com
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-800-444-3353 as soon as possible.
Copyright© 2012 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product
described herein. Tools required for assembly and service may not be included.
ITEM 69462
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Specifications
Battery Type AA NiCd rechargeable
Battery Rating 300mAh
Running time when
fully charged
Important Safety Information
8 hours
1. Assemble only according to these
instructions. Improper assembly
can create hazards.
2. Wear ANSI-approved safety goggles
during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the
area during assembly.
5. Do not assemble when tired
or when under the influence
of drugs or medication.
6. Position battery in proper polarity and
do not install batteries of different types,
charge levels, or capacities together.
7. WARNING: The brass components of
this product contain lead, a chemical
known to the State of California
to cause birth defects (or other
reproductive harm). (California Health
& Safety code § 25249.5, et seq.)
8. This product is not a toy. Do not allow
children to play with or near this item.
9. Use as intended only.
10. Inspect before every use; do not use
if parts are loose or damaged.
11. Maintain product labels and
nameplates. These carry
important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Page 2 For technical questions, please call 1-800-444-3353. Item 69462
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1. Unthread the two screws on the battery cover and remove the battery cover.
2. Insert the AA battery into the battery housing paying attention to the polarity.
3. Replace the Battery cover and secure with the screws.
4. Set one of the Decorative LED Shapes (2) onto the Top Tube (3). Slide the Top
Tube (3), into the Bottom Tube (4). Slide the Stake (5) onto the Bottom Tube (4).
5. Repeat steps 1 - 3 for the other two light sets.
Functions
Decorative LED Shape (2)
Top Tube (3)
Battery Cover (9)
(On back of Solar Panel)
Power Switch (7)
(On back of Solar Panel)
Solar Panel (1)
Bottom Tube (4)
Stake (5)
Figure A
Page 3For technical questions, please call 1-800-444-3353.Item 69462
Loading...