Harbor Freight Tools 69461 Owner's Manual

Specifications

Light Bulb White LED

Battery Type AAA NiCd

Charge Time 6 hr.

Running Time 9 hr.

Solar Cells Amorphous Silicon

Important Safety Information

1. Assemble only according to these instructions. Improper assembly can create hazards.

2. Wear ANSI-approved safety goggles during setup.

3. Keep assembly area clean and well lit.

4. Keep bystanders out of the area during assembly.

5. Do not assemble when tired or when under the influence of drugs or medication.

6. Position battery in proper polarity and do not install batteries of
different types, charge levels, or capacities together.

7. WARNING: The brass components of this product contain lead, a
chemical known to the State of California to cause birth defects (or other
reproductive harm). (California Health & Safety code § 25249.5, et seq.)

8. This product is not a toy. Do not allow children to play with or near this item.

9. Use as intended only.

10. Inspect before every use; do not use if parts are loose or damaged.

11. Maintain product labels and nameplates. These carry important safety information.
If unreadable or missing, contact Harbor Freight Tools for a replacement.

Page 2 For technical questions, please call 1-800-444-3353. Item 69461

Setup Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.

Note: For additional information regarding the parts listed in the following

pages, refer to the Assembly Diagram near the end of this manual.

Battery Setup

There may be a paper tab in one end of the battery between the Battery (5) and
the electrical contact so the Battery won’t drain over time. To remove this:

1. Twist the Lamp Cover off the Lamp Housing.

2. Unthread the two screws on the battery cover and remove the battery cover.

Caution: Be careful that the two wires holding the battery cover
to the Lamp Housing are not pulled and disconnected.

3. Pull out the paper tab.

4. Replace the Battery cover and secure with the screws.

5. Replace the Lamp Cover onto the Lamp Housing.

6. Repeat steps 1 - 5 for the other lights.

Functions

Battery Cover

(On Lamp Housing)

and Battery (5)

(Inside Lamp Housing)

Power Switch (7)

(On Battery Cover

of Lamp Housing)

Lamp Housing (1)

Lamp Cover (2)

Figure A

Pole (3)

Stake (4)

Page 3For technical questions, please call 1-800-444-3353.Item 69461