Harbor Freight Tools 68116, 69068 Product manual
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual
near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference.
9-PIECE CARBIDE
GRIT HOLE SAW SET
Visit our website at: http://www.harborfreight.com
Email our technical support at: tech@harborfreight.com
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-800-444-3353 as soon as possible.
Copyright© 2011 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product
described herein. Tools required for assembly and service may not be included.
ITEM 68116 / 69068
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
SPECIFICATIONS
Type Carbide Grit
Piece Count 9
Saw Sizes 1-1/4″, 2-1/8″, 2-5/8″, 2-7/8″, 3-1/4″
Carbide Grit File
Other Pieces
Backing Plate
Pilot Bit
Blow Molded Case
IMPORTANT SAFETY INFORMATION
The warnings, cautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
1. Wear ANSI-approved safety goggles
and heavy-duty work gloves
during setup and use.
2. Keep away from children.
3. Verify drill’s chuck is in good
condition and ts securely.
SAVE THESE INSTRUCTIONS.
4. Do not use excessive pressure
when cutting a hole.
5. Use as intended only;
do not modify tools.
6. Inspect before every use; do not
use if parts are loose or damaged.
7. Use both hands when drilling and
keep saw at 90° to workpiece.
8. Store saws in Case in secure
location away from children.
9. Do not exceed 1500 RPM.
10. Read and adhere to all safety
warnings and operating instructions
of drill used with Set.
Page 2 For technical questions, please call 1-800-444-3353. Item 68116/69068
Loading...