Harbor Freight Tools 65939 User Manual
65939
INSTRUCTIONS AND PRECAUTIONS
WELDING
CART
Distributed exclusively by Harbor Freight Tools®.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
SAVE THESE INSTRUCTIONS. READ ALL
PRECAUTIONS AND INSTRUCTIONS.
Copyright© 2008 by Harbor Freight Tools®. All rights reserved. No portion of this document or any artwork contained
herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this document may not be drawn proportionally. Due to continuing improvements, actual product
may differ slightly from the product described herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
UNPACKING
When unpacking, make sure that the item
is intact and undamaged. If any parts are missing
or broken, please call Harbor Freight Tools at the
number shown on the cover of this document as
soon as possible.
IMPORTANT SAFETY
INFORMATION
Assembly Precautions
Assemble only according to these instruc-1.
tions. Improper assembly can create hazards.
Wear ANSI-approved safety goggles and 2.
heavy-duty work gloves during assembly.
Keep assembly area clean and well lit.3.
Keep bystanders out of the area during as-4.
sembly.
Do not assemble when tired or when under 5.
the inuence of drugs or medication.
Use Precautions
Avoid working alone. If an accident occurs, 1.
an assistant can get help.
This product is not a toy. Do not allow chil-2.
dren to play with or near this item.
Use for intended purpose(s) only.3.
Always store acetyline and oxygen tanks 4.
away from ammable materials and heat
sources.
Inspect before use; check welds for cracks.5.
Wear the proper face mask and gloves for 6.
welding purposes.
Make sure tanks are securely strapped to the 7.
cart.
Store and use this cart only on at and level 8.
surfaces.
After welding, make sure gas valves are 9.
securely tightened.
Read and understand the warnings and 10.
instructions provided by the manufacturer of
the welding equipment being used.
Maintenance should be performed by a quali-11.
ed technician.
Maintain product labels and nameplates. 12.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
Assembly
Tank Frame (4)
Axle
Brackets (7)
Bottom
Tray
Bafe
Board (11)
Fig. 1
1. Start with the welded Tank Frame (4) as this
is where everything else attaches.
Handle
Tank
Frame (4)
Axle
Brackets (7)
(1)
Tool
Tray (3)
Tool Tray
Bracket
(2)
ASSEMBLY INSTRUCTIONS
Axle (6)
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this document including
all text under subheadings therein
before set up or use of this product.
2. Line up the holes of the Handle (1) and the
Tool Tray Bracket with the holes at the upper
Fig. 2
sides of the Tank Frame (4).
Fit two Screws (9) through the holes in the 3.
Handle (from the outside in), Tank Frame
side, and the Tool Tray Brackets on the
inside of the Tank Frame, and screw on two
Washers and Nuts.
SKU 65939 For technical questions, please call 1-800-444-3353. Page 2
Loading...