Harbor Freight Tools 63847 Owner's Manual & Safety Instructions

Owner’s Manual & Safety Instructions

Save This Manual Keep this manual for the safety warnings and precautions, assembly,

operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back
of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep
this manual and the receipt in a safe and dry place for future reference. 20g

Visit our website at: http://www.harborfreight.com

Email our technical support at: [e-mail]

When unpacking, make sure that the product is intact

and undamaged. If any parts are missing or broken,

please call 1-888-866-5797 as soon as possible.

Copyright© 2020 by Harbor Freight Tools®. All rights reserved.

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product described herein.

Too l s r e q ui r e d f o r a s s em b l y a n d s e rv i c e m a y n o t b e i n c lu d e d.

Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.

WARNING SYMBOLS AND DEFINITIONS

This is the safety alert symbol. It is used to alert you to potential personal injury hazards.

Obey all safety messages that follow this symbol to avoid possible injury or death.

Indicates a hazardous situation which, if not avoided,

will result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

Indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury.

Addresses practices not related to personal injury.

Specifications

Battery Requirement Two D-Cell (not included)

Delivery Hose Length 24"

Suction Hose 13" L x 1" Diameter

Flow Rate Approximately 6 Quarts / Min

Compatible Fluids

Gasoline, Water, Oil, other
Non-Corrosive Liquids

IMPORTANT SAFETY INFORMATION

WARNING Read all safety warnings and instructions.

Failure to follow the warnings and instructions may result in serious injury.

Save all warnings and instructions for future reference.

1. Do not use with corrosive liquids. Not for use with
drinking water.

2. When pumping gasoline and flammable liquids,
be alert to possible explosion hazard. Flammable
fluid fumes and gasoline vapors can be an
explosive hazard. Avoid sparks and use only
with adequate ventilation.

3. Wear ANSI-approved safety goggles and heavy-duty,
chemical resistant work gloves during use.

4. This product is not a toy. Do not allow children to
play with or near this item.

5. Use as intended only. Only use pump for transferring
gasoline, water, oil, and other non-corrosive liquids.

6. Do not use if Pump is hot.

7. Verify that all connections are tight before use to
eliminate leaking.

8. Do not pump used, dirty oil.

9. Do not use near open flame or heat sources.

10. Do not turn Pump upside down after use.

11. Remove batteries when not in use.

12. Know and obey city and state laws for proper
disposal of oil and gasoline. Dispose of properly in
accordance with all local laws and regulations.

13. Follow all guidelines regarding materials being
pumped, including SDS instructions and
EPA regulations.

14. Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel­cadmium) batteries. Position batteries in proper
polarity. Do not use swollen or leaking batteries.

15. Do not operate when tired or when under
the influence of drugs or medication.

16. Inspect before every use; do not use if parts are
loose or damaged.

17. Maintain product labels and nameplates. These
carry important safety information. If unreadable
or missing, contact Harbor Freight Tools for
a replacement.

SAVE THESE INSTRUCTIONS.

Page 2 For technical questions, please call 1-888-866-5797. Item 63847

Operating Instructions

Read the ENTIRE WARNING section at the beginning of this manual including all text under
subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the

Parts List and Diagram on page 4.

Battery Installation

1. Unscrew Battery Cap counterclockwise and remove.

2. Insert two D-Cell batteries (not included) into the
Battery Housing. Be sure to install batteries in
proper polarity. Do not install batteries of different
types, charge levels, or capacities together.

3. Replace the Battery Cap and tighten securely.

ON/OFF

Switch

Battery Cap

Battery Housing

Figure A

Operation

1. Insert the Suction Tube as far as possible into the
liquid to be transferred.

2. Place the Delivery Hose into a container (not
included) in which to pump the liquid. Do not place
receiving container higher than the Battery Housing.

3. Turn the ON/OFF Switch to ON. Make sure
the battery compartment remains sealed during
operation.

Maintenance

Procedures not specifically explained in this manual must be performed
only by a qualified technician.

TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise
or vibration occurs, have the problem corrected before further use.

1. BEFORE EACH USE, inspect the general condition
of the Liquid Transfer Pump. Check for:

• loose hardware

• misalignment or binding of moving parts

• cracked or broken parts

• any other condition that may affect its
safe operation.

NOTICE: Do not run unit dry. Make sure Suction Tube
is fully submerged in liquid before turning on.

4. When the transfer is complete, turn the Switch OFF.
After use, do not turn Pump upside down.

5. Rinse unit with water and wipe dry. Remove
batteries and store in a clean, dry location out of
reach of children.

2. AFTER USE, rinse Pump with water.
Wipe unit dry after cleaning.

3. Remove batteries. Store the Liquid Transfer Pump
in a clean, dry location out of reach of children.

Page 3For technical questions, please call 1-888-866-5797.Item 63847

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY

ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

Parts List & Diagram

Part Description Qty

1 Battery Cover / ON/OFF Switch 1

2 Neck Ring 1

3 Battery Housing 1

4 Circuit Board 1

5 Pump Housing 1

6 Suction Tube 1

7 Seal 1

14

15

1

2

3

4

5

8 Motor Housing 1

9 Motor 1

10 Seal 1

11 Washer 1

6

12 Impeller 1

13 End Cap 1

14 Delivery Hose Ring 1

15 Delivery Hose 1

Record Serial Number Here:
Note: If product has no serial number, record month and year of

purchase instead.
Note: Some parts are listed and shown for illustration purposes

only, and are not available individually as replacement parts.

7

8

9

10

11

12

13

Specify UPC 193175350930 when ordering parts.

Limited 90 Day Warranty

Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards,
and warrants to the original purchaser that this product is free from defects in materials and workmanship for the
period of 90 days from the date of purchase. This warranty does not apply to damage due directly or indirectly,
to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper
installation, normal wear and tear, or to lack of maintenance. We shall in no event be liable for death, injuries
to persons or property, or for incidental, contingent, special or consequential damages arising from the use of
our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation of exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER

WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.

To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid.
Proof of purchase date and an explanation of the complaint must accompany the merchandise. If our inspection
verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase
price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our
expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our
warranty, then you must bear the cost of returning the product. This warranty gives you specific legal rights and you
may also have other rights which vary from state to state.

26541 Agoura Road ● P. O. Box 6009 ● Calabasas, CA 91302 ● 1-888-866-5797