WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
Important Safety Information
WARNING Read all safety warnings and instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference. The warnings,
precautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Installation Precautions
will result in death or serious injury.
1. Install all sensitive electrical
components (including wiring
connections, regulator, and battery)
inside a weatherproof enclosure
to prevent electric shock.
2. Do not wire multiple panels in series.
If you need to connect two or more solar
panels together, this work must be done
by a qualified electrician unless they
are connected through a regulator.
3. This solar panel kit is not designed for tiein to a grid. Only a licensed electrician
and a licensed building contractor can
safely design and implement a grid
tie-in system. Any grid tie-in system
must meet all applicable building
and electrical codes, and must meet
Page 2 For technical questions, please call 1-800-444-3353. Item 60449
standards established by the area power
company. Improper grid tie-in can result
in electrocution, fire, and other serious
personal injury and property damage.
An incorrectly installed grid tie-in system
can cause feedback voltage, resulting in
electrocution of electrical utility workers.
4. Do not apply pressure or press down
on the Solar Charger when it is folded.
5. Do not focus light on panel.
6. This product may occasionally
produce more current and/or voltage
than its rated output. Increase
output ratings by 25% when
determining component required
voltage and amperage ratings.
Refer to Section 690-8 of the National
Electrical Code for an additional
multiplying factor of 125 percent (80
percent derating) which may apply.
7. Do not attach to battery or power
grid without proper regulator,
inverter, and/or charge controller.
8. Install and use according to
applicable National Electrical
Code (NEC) standards.
9. Verify that installation surface
has no hidden utility lines before
drilling or driving screws.
Service Precautions
10. Install only according to these
instructions. Improper installation
can create hazards.
11. Wear ANSI-approved safety goggles
and heavy-duty work gloves during
installation. Do not wear jewelry or
metal watches when working near
solar panels, wiring or batteries.
12. Keep installation area clean and well lit.
13. Keep out of reach of children.
14. Keep bystanders out of the
area during installation.
15. Do not install when tired or when under
the influence of drugs or medication.
1. Disconnect items being
charged before cleaning.
2. Do not allow children to play with or
near this item or electrical components.
3. Inspect before each use; do not
use if damaged, parts are loose,
water is found inside the housing,
electrical insulation is cracked or
damaged, or connections are loose.
SAVE THESE INSTRUCTIONS.
4. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
5. WARNING: Handling the cord on this
product will expose you to lead, a
chemical known to the State of California
to cause cancer, and birth defects or
other reproductive harm. Wash hands
after handling. (California Health &
Safety Code § 25249.5, et seq.)
Page 3For technical questions, please call 1-800-444-3353.Item 60449