Harbor Freight Tools 46798 User Manual

ELECTRONIC EARMUFFS

The EPA has selected the NRR as the measure of a hearing protector’s noise reducing capabilities.
Harbor Freight Tools makes no warranties as to the suitability of the NRR as a measure of actual
workplace protection since such protection is highly dependent on user training, motivation, and utilization.
A better estimate of workplace protection can be obtained by derating the labeled NRR by 50%.

The NRR calculated from this attenuation data is 24. Improper fit of this device will reduce its effectiveness
in attenuating noise. Consult instructions for proper fit.

The level of noise entering a person’s ear, when a hearing protector is worn as directed, is closely
approximated by the difference between the A-weighted environmental noise and the NRR.

tseT

)zH(seicneuqerF

naeM

)Bd(noitaunettA

dradnaS

)Bd(noitaiveD

Example:

1.) The environmental noise le vel as measured at the ear is 92 dBA.

2.) The NRR is 24 decibels (dB).

3.) The level of noise entering the ear is appro ximately equal to 68 dBA.

environmental noise level should be used.

For noise environments dominated by frequencies below 500 Hz, the C- weighted

4791-91.3SISNAATADNOITAUNETTA

521052005000100020513000400360008

9.21.718.727.633.549.146.545.732.93

0.24.12.16.36.23.18.15.21.2

RRN

7242

tuohtiw(

)noitcerroc112RFC04

ITEM 46798

detcerroC

RRN

The NRR used in the above example was achie ved under labor atory conditions.
Although hearing protectors can be recommended for protection against harmful effects of

impulsive noise, the Noise Reduction Rating (NRR) is based on the attenuation of continuous
noise and may not be an accurate indicator of the protection attainable against impulsive noise
such as gunfire.

Wear Instructions

1. Adjust the band to the proper position.

2. Pull hair out of the way and out from beneath the muffs .

3. Adjust the height of the cups so they fully enclose the
ears and the cushions press equally around the ear.

4. It is important that cushions seal completely around the
ear.

5. Always wear ANSI approv ed safety glasses when working
with tools and equipment. When using these ear muffs
with safety glasses, saf ety glasses must have thin temples
that fit closely around the head or thin straps, this will help
ensure a better fit and better protection.