Hanwha Techwin America SHB-D-9000H User Manual
BOX CAMERA HOUSING
User Manual
SHB-D-9000H
BOX CAMERA HOUSING
User Manual v1.1 7-2020
Copyright
©20
20 Hanwha Techwin America, All rights reserved.
Trademark
Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the
registered trademark of their respective company.
Restriction
Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed,
partially or wholly, without formal authorization.
Disclaimer
Hanwha Techwin America makes the best to verify the integrity and correctness of the contents in this document, but no
formal guarantee shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own
responsibil-ity. Hanwha Techwin America reserves the right to change the contents of this document without prior notice.
Design and specifications are subject to change without prior notice.
Hanwha Techwin America
Technical Support
(877) 213-1222
Introduction
PRODUCT OVERVIEW
y
This camera housing is designed to install the TNB-9000 camera and compatible lenses for
use in indoor and outdoor locations securely to protect it from external
conditions.
mount arm and accepts a wide range of input voltages.
The included
IP67 rated power supply is integrated in to the wall
FEATURES
y
This product provdes 16.5” x 7" x 6" of usable space which is designed to provide
protection from outdoor and harsh indoor environments for stable operation.
y
Independently thermostatically controlled solid-state cooler & heater.
y
IP66 rated fan provides ventilation while preventing moisture ingress.
y
Aluminum housing body and stainless steel wall mount with integrated power supply.
y
Anti-Reflective, Low Iron coating on both sides provides high optical performance with 18°
angle.
Contents of Box
A
B
D
J
E
F
H
I
C
K
G
A. Enclosure/housing
B. Wall mount arm
C. Outdoor power supply (Can be mounted inside wall mount arm)
D. Power supply mounting screws and washers
E. Camera mounting bolts and washers
F. Cable management sleeve inside wall mount arm
G. Rechargeable desiccant humidity removal pack
H. Allen wrench tool for adjusting knuckle wall mount arm
I. Wall mount screws and anchors
J. Threaded locknut
K. Camera sled pre-installed
Tools needed
1. Phillips screwdriver
2. Socket wrench
3. Electronics size at screwdriver
Loading...