Hans Turck and KG TNLRQ80L800 User Manual

read/write head TNLR-Q80L800-H1147
Type code TNLR-Q80L800-H1147
Ident no. 7030522
Mounting conditions non-flush Ambient temperature -25…+70 °C
For roller conveyors
The approach direction of the data car-
rier can be transversal as well as longi­tudinal to the read/write head.
Rectangular, 80 x 800 mm, height 25
mm
Active face on top
Plastic, PBT-GF30-V0
Powered and operated only via BL ident
interface module
Male M12 x 1, only for use with BL ident
extension cable
Connectors …/S2503
Data transfer inductive coupling Operating frequency 13.56 MHz Radio communication and protocol standards ISO 15693 Output function 4-wire, read/write
Construction rectangular, Q80L800 Dimensions 800x 80x 25mm Housing material plastic, PBT, black Material active area plastic, Black
Connection male, M12 Vibration resistance 55 Hz (1 mm) Shock resistance 30 g (11 ms) IP Rating IP67 Power-on indication LED green Diagnostic display Functional description of yellow range-restrict-
ed LED: If the read/write head is supplied with voltage, it briefly checks to see whether its resonance frequency is affected by sur­rounding metal. If this is the case, the reso­nant circuit off-tunes its frequency to reach again the (optimum) resonance frequency. However, this is only possible within a cer­tain range. If too much metal is in the envi­ronment, the read/write head cannot re-tune or the surrounding metal takes too much en­ergy from the field and due to the reduced range the communication between the read/ write head and the data carrier is cut off (the orange range-restricted-LED lights up). If the LED is off, this does not mean conversely, that no reduction in range occurs. The lit LED is rather an indication of too much metal in the environment and a greatly reduced range (about 50% less).
Packaged quantity 1
Connectors …/S2500
Connectors …/S2501
Functional principle
The HF read/write heads operating at a fre­quency of 13.56 MHz form a transmission zone the size of which (0…500 mm) varies, depending on the combination of read/write head and data carrier.
The read/write distances mentioned here on­ly represent standard values measured under laboratory conditions.
The read/write distances of the data carriers for mounting in metal TW-R**-M(MF) were de­termined in metal.
Attainable distances may vary by up to 30 % due to component tolerances, mounting con­ditions, ambient conditions and material quali­ties (especially when mounted in metal)
Testing of the application under real operat­ing conditions is therefore essential, especial­ly with read/write on-the-fly!
Edition • 2015-08-27T10:30:45+02:00
1 / 1 Hans Turck GmbH & Co.KG ñ D-45472 Mülheim an der Ruhr ñ Witzlebenstraße 7 ñ Tel. 0208 4952-0 ñ Fax 0208 4952-264 ñ more@turck.com ñ www.turck.com
Qty
1
1615H
Type
TNLR-Q80L800-H1147
Ident-No.
Warning:Hazardous voltage can cause electrical shock and burns. Disconnect power before proceeding with any work on this equipment. Made in Germany Hans Turck GmbH & Co. KG · Witzlebenstraße 7 · 45472 Mülheim/Ruhr · Germany Phone +49 208 49 52-0 · Fax +49 208 49 52-264 · more@turck.com · www.turck.com
7030522
24 VDC