Hans Grohe 39020XX1 User Manual
Installation Instructions / Warranty
Axor Citterio
39020XX1
2
Axor Citterio Tall Lav Mixer 39020XX1
Technical Data
Recommended hole size 1 3/8“
Maximum depth of mounting surface 1 1/2“
Flow rate @ 45 psi 2.2 gpm
Maximum water pressure 145 psi
Recommended water pressure: 14.5 - 75 psi
Recommended hot water temp.: 120oF - 140oF*
The supply hoses require supply stops with 3/8“ compression fittings (not included).
For best results, Hansgrohe recommends that this faucet be installed by a licensed professional
plumber.
*Please know and follow all applicable local codes when setting the temperature on the water heater. In
Massachusetts, the water heater may be set no higher than 112oF.
Prepare to install the faucet:
Prior to installation, install supply stops with 3/8” outlets. The supply hoses will attach to the supply stops with 3/8” compression fittings. Neither the supply stops nor the compression fittings are
provided by Hansgrohe.
Flush the supply lines thoroughly. Damage to the faucet caused by debris in the water line is not
covered under the limited lifetime warranty.
Install the faucet:
Place the faucet and sealing ring on top of the mounting
surface.
From beneath the mounting surface, install the friction
washer, metal washer, and mounting nut. Tighten the
tensioning screws.
sealing ring
friction washer
metal washer
mounting nut
tensioning screws
Connect the hoses to the stops, using 3/8” compression
fittings (not included). Use two wrenches, as shown, to
prevent the hoses from twisting.
Install the pull rod. Install the drain.
Turn on the water and check all connections for leaks.
3
Loading...