Hans Grohe 32020XX1 User Manual

Installation Instructions / Warranty

Talis S

32020XX1

2

Talis S Lavatory Mixer

32020XX1

32020XX1

Technical Specification

Flow Rate 2.2 gpm
Max incoming water pressure 145 psi
Recommended incoming water pressure 14.5 - 72 psi
Max incoming hot water temperature 176oF*
Recommended incoming hot water temp. 120

o

F - 140oF*
Maximum mounting surface thickness 1 1/2”
Hole size 1 1/4”

*Prevent accidental scalding - know and follow all applicable local plumbing codes when setting the temperature on the water heater!

Installation Considerations

This faucet requires supply stops with 3/8” compression fittings (not included).
Please be sure that the faucet is in good condition, and that all parts are present before beginning
installation.
Flush the supply lines thoroughly before installing the faucet. Damage to the cartridge caused by
debris is not covered by the Hansgrohe USA Limited Lifetime Warranty.
The faucet includes a high temperature limit stop which should be re-set to protect children from
accidental scalding.
Installer - please leave this manual for the homeowner as it contains important information on the
faucet.

3

666

1

2

3

Installation

If the mounting surface is greater than 3/16”, leave
the spacer ring intact.

Place the mounting plate over the stud. Tighten the
collar so that it is snug against the bottom of the mount­ing surface.

Install the supply hoses to the stops with the compres­sion fittings, taking care not to twist the supply hoses.

Install the pop-up drain.

Re-set the high temperature limit stop.

Turn on the water and test all connections for leaks.

If the mounting surface is less than 3/16” thick, care­fully trim the spacer ring so that it is even with the
bottom of the faucet.