Hans Grohe 31730001, 31263XX1, 31063XX1 User Manual

Installation Instructions / Warranty

Metris

31063XX1

Talis

32310XX1

Metris

31263XX1

Focus

31730001

2

Metris Widespread Lavatory Faucet 31063XX1
Metris Widespread Bidet Faucet 31263XX1
Talis S Widespread Lavatory Faucet 32310XX1
Focus Widespread Lavatory Faucet 31730XX1

Product Information

Requires 1/2" supply lines (not included)
Max. mounting surface thickness 1 1/8"
Hole sizes in mounting surface
Spout 1 3/8"
Valves 1 1/4"
Max. incoming water pressure 145 PSI

Recommended incoming water pressure 22 - 72 PSI
Max. incoming hot water temp. 176°F*
Recommended incoming hot water temp. 120° - 140°F*
Max. flow rate -- lavatory faucets 2.2 gpm
Max. flow rate -- bidet faucet 2.2 gpm

The bidet faucet is not suitable for use on vertical spray bidets.
This faucet may be used with a continuous flow water heater if the flow pressure is at least 20 PSI.
For best results, Hansgrohe recommends that this faucet be installed by a licensed, professional plumber.

*Please know and follow all applicable local codes when setting the temperature on the water heater.

31063XX1

31263XX1

32310XX1

Note:

To prevent shipping damage, the spout is attached to the
spout escutcheon with two adhesive strips. These strips
must be removed before the spout is installed.

Loosen the spout screw with a 2.5 mm Allen wrench.Pull
the spout away from the escutcheon.

Remove the adhesive strips.

Reassemble the spout assembly so that the hole for the
pull rod is at the rear of the spout.

adhesive strips

31730XX1

3

4

Installation

Remove the valve mounting nuts from the valves.

From below the mounting surface, push the valves up into
the holes. Install the mounting nuts on the valves.

Tighten the tensioning screws.

Place the handles over the valve mounting nuts. Tighten
the handles by rotating the escutcheons clockwise.

The handles should be parallel to the basin. If necessary,
loosen the tensioning screws and rotate
the valve slightly.

Install the spout. Rotate the spout escutcheon if necessary,
so that the hole for the pull rod is at the rear.

Tighten the mounting nut. Tighten the tensioning screws.