Hans Grohe 31103XX1, 31102XX1 User Manual
Installation Instructions / Warranty
Metris
31102XX1
Metris
31103XX1
2
Metris Electronic Lavatory Faucet with Temperature Control
31102XX1
Metris Electronic Lavatory Faucet
31103XX1
Technical Data
Max. water pressure 116 psi
Recommended pressure 14.5 - 72 psi
Max. hot water temp. 158oF*
Recommended hot water temp. 120oF - 140oF*
Flow rate 1.5 gpm @ 44 psi
Automatic shutoff after 35 seconds
Hole size in mounting surface 1 1/4”
Max. mounting surface thickness 1 1/8”
Requires standard 110 V electrical outlet**
This faucet cannot be used with a continuous flow water
heater.
For best results, Hansgrohe recommends that this unit be
installed by a licensed, professional plumber.
*Please know and follow all applicable local plumbing codes when setting
the temperature on the water heater. In Massachusetts, the water heater
may be set no higher than 112oF.
**Please know and follow all applicable local codes regarding placement
and type of electrical outlet.
Caution: Do not bend or twist the supply hoses!
Installation
Flush the hot and cold supplies thoroughly before installing this faucet.
Place the faucet in the hole on the mounting surface (1).
Tighten the mounting nut (2).
Install the adapters and filters on the stops (3).
Install the supply lines (4). Be careful not to twist the
supply lines, or they may become loose from the faucet,
causing a leak.
Connect the transformer to the faucet. Plug the transformer into the outlet.
Use a cable tie to bundle the excess cable.
3
4
Turn the water on to the faucet (1).
Peel the protective film from the sensor (2).
Wait 15 seconds, the place a hand in front of the sensor
(3). The water should turn on automatically.
Model 31102 only: Pivot the temperature control
lever forward to make the water cooler (4).
Model 31103 only: Set the temperature
Turn the water off at the stops.
Remove the set screw on the back of the faucet.
Pull the faucet housing off (1).
Use a screwdriver to set the water temperature (2). Turn
the screw to the rear to make the water warmer, to the
front to make it cooler.
Replace the faucet housing. Tighten the set screw.
Loading...