Hans Grohe 31101XX1, 31100XX1 User Manual

Installation Instructions / Warranty

Metris

31100XX1

Metris

31101XX1

2

Metris Electronic Lavatory Faucet with Temperature Control
31100XX1
Metris Electronic Lavatory Faucet
31101XX1

Technical Data

Max. water pressure 116 psi
Recommended pressure 14.5 - 72 psi
Max. hot water temp. 158°F*
Recommended hot water temp. 120°F - 140°F*
Flow rate 1.5 gpm @ 44 psi
Automatic shutoff after 35 seconds
Hole size in mounting surface 1 1/4”
Max. mounting surface thickness 1 1/8”

For best results, Hansgrohe recommends that

•
this unit be installed by a licensed, professional
plumber.

This faucet is listed by IAPMO and is approved for

•
use in Massachusetts.

This faucet cannot be used with a continuous flow

•
water heater.

*Please know and follow all applicable local plumbing codes when
setting the temperature on the water heater.

Caution: Do not bend or twist the supply hoses!

Installation

Flush the hot and cold supplies thoroughly before install­ing this faucet.

Place the faucet in the hole on the mounting surface (1).

Tighten the mounting nut (2).

Install the adapters and filters on the stops (3).

Install the supply lines (4). Be careful not to twist the
supply lines, or they may become loose from the faucet,
causing a leak.

3

4

Turn the water on to the faucet (1).

Peel the protective film from the sensor (2).

Wait 15 seconds, the place a hand in front of the sensor
(3). The water should turn on automatically.

Model 31100 only: Pivot the temperature control
lever forward to make the water cooler (4).

Model 31101 only: Set the temperature

Turn the water off at the stops.

Remove the set screw on the back of the faucet.

Pull the faucet housing off (1).

Use a screwdriver to set the water temperature (2). Turn
the screw to the rear to make the water warmer, to the
front to make it cooler.

Replace the faucet housing. Tighten the set screw.