Hansgrohe 31020001 Assembly manual
Installation Instructions / Warranty
Metris
31060XX1
31020XX1
31261XX1
2
Metris
Single Control Lavatory Mixer 31060XX1
Tall Lavatory Mixer 31020XX1
Single Control Bidet Mixer 31261XX1
31060XX1 31261XX1
31020XX1
Technical Specification
Recommended incoming water pressure 22 - 72 PSI
Recommended incoming hot water temperature 120o - 140oF*
Hole size in mounting surface 1 3/8”
Maximum mounting surface thickness 1 5/8”
Flow rate 2.2 gpm max.
Supply hoses require stops with 3/8” compression fittings (not included)
Bidet mixer 31261XX1 is not intended for use on a bidet with a vertical spray.
*some municipalities have codes limiting the maximum temperature of the water heater to 120oF or less. Please know and follow all applicable
local codes when setting the temperature on the water heater.
User Instructions
Pivot the handle up to turn the water on. Pivot it down to turn the water off.
Pivot the handle to the right to obtain cooler water, to the left to obtain warmer water.
Installation
Place the faucet and the sealing ring on the countertop.
From below, install the fiber washer, friction washer and
mounting nut. Tighten the mounting nut and the tensioning screws.
sealing ring
fiber washer
friction washer
mounting nut
tensioning screws
Attach the hoses to the supply stops with 3/8” compression fittings (not included). Use two wrenches, as shown,
to prevent the hoses from twisting or from becoming
loose.
Install the pop-up drain (see page 4).
Turn on the water and check all connections for leaks.
3
Loading...