Installation Instructions / Warranty
Aktiva A’8 Handshower
28547XX1
Aktiva A’8 Handshower
28547XX1
Technical Specification
Flow Rate 2.5 gpm
Maximum operating pressure 90 psi
Max hot water temperature 140
4 Spray modes:
normal spray
soft spray
massage
mono spray
*Know and follow all applicable plumbing codes when setting the temperature on the water heater
The Water Dimmer
o
F*
The water dimmer switch is located on
the front of the handshower. In the top
position, the water flow is at its maximum. The bottom position is the Eco
setting - up to 50% water savings.
Note to US Users: Due to the mandatory 2.5 gpm flow restrictor, the effect of
the water dimmer is not as noticible as
designed.
Installation
Place a black rubber hose washer
in one end of the handshower hose.
Screw the hose to the end of the handshower.
2
Cleaning the Dirt-Blokker Filter
With the handshower attached to the hose, use a coin
to turn the filter access screw counter-clockwise.
Pull the handshower away from the Dirt-Blokker.
Flush the Dirt-Blokker.
Reattach the handshower.
Turn the access screw clockwise to lock.
3