Hans Grohe 28110XX1, 2810BXX1 User Manual

Installation Instructions / Warranty

Raindance Allrounder

28110XX1

Wall Outlet Adapter with Hose

Connection

28108XX1

2

Raindance Allrounder
28110XX1

Determining the mounting height (X)

Technical Data

Max. flow rate of showerhead 2.5 gpm

The Allrounder should be mounted according to the preferences of the users. It should be conve­nient for all adult users.

Install the Allrounder with the Optional Wall Outlet
Adapter with Hose Connection 28108XX1

If you are not using the 28108XX1 wall outlet adapter, go to page 9.

Roughing in

Install a properly anchored 1/2" NPT drop-eared ell, at
least 2" behind the surface of the finished wall. Install a
test nipple in the ell.

When the finished wall is complete, mark the test nipple at
the wall surface. Remove the test nipple.

Measure the test nipple to the mark.

Subtract 3/8" from this measurement. This is the length
of the brass nipple required to install the wall outlet
adapter.

3

4

Installation

Wrap both ends of the brass nipple with Teflon tape.
Screw it into the mounting piece.

Screw the test nipple / mounting piece assembly into the
drop-eared ell.

Tighten with a 12 mm Allen wrench (not included).

Do not overtighten, or damage will
result.

Seal the wall around the mounting piece with water­proof sealant.

Position the mounting plate over the mounting piece.
Use a grease pencil or similar tool to mark the position
of the screw holes.

Drill the holes with a 6 mm bit. Use extreme caution

- do not drill into the water line.

Install the anchors.

Seal the wall around the anchors
with waterproof sealant.

Failure to seal the wall can lead
to possible water damage.

Install the mounting plate, using the screws and offset
bushings provided.

Remove the long bottom mounting screw on the All­rounder. Replace with the shorter screw included with
the adapter.

5