Hans Grohe 18010001, 18210001 User Manual
Installation Instructions / Warranty
Massaud
18010001
Massaud
18210001
2
Axor Massaud Single-Control Lavatory Faucet
18010001
Axor Massaud Single-Control Bidet Faucet
18210001
18010001
Do not allow the supply hoses to bend
or twist!
18210001
Product Specification
Max. Flow Rate 2.2 gpm
Max. incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Max. hot water temperature 176o F*
Recommended hot water temp 120oF - 140oF*
Hole size in mounting surface
18010001 1 1/4”
18210001 1 3/8”
Max. mounting surface thickness 1 5/8”
Model 18010001 has 10 mm supply hoses -- 10 mm - 3/8” adapters included.
No drain or pull rod is included with model 18010001. Grid drain 06400000 (not included) is
recommended.
Model 18210001 has 3/8” supply hoses. 3/8” compression fittings are required (not included).
A pop-up drain is included with 18210001.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts,
the water heater may be set no higher than 112oF.
Installation
Position the faucet and sealing ring on the mounting
surface.
From beneath the mounting surface, install the fiber
washer, metal washer, and mounting nut. Tighten the
tensioning screws.
18010001 only: Install the adapters on the stops.
Install the filters on the adapters.
3
4
Slide the compression nut, cone washer, metal washer,
and rubber washer over the end of the supply hose.
Place the supply hose in the filter.
Tighten the compression nut to the filter, using two wrenches, as shown in the diagram, to prevent the supply hose
from twisting.
18210001 only: Secure the supply hoses to the stops
with 3/8” compression fittings (not included). Use two
wrenches, as shown, to keep the hoses from twisting.
Turn on the water and check all connections for leaks.
Install the pull rod (model 18210001 only).
Install the pop-up drain (model 18210001 only).
Turn on the water and check all connections for leaks.
Loading...